Cypress CY4607 HX2VL Руководство - Страница 7

Просмотреть онлайн или скачать pdf Руководство для Микроконтроллеры Cypress CY4607 HX2VL. Cypress CY4607 HX2VL 9 страниц.
Также для Cypress CY4607 HX2VL: Краткое руководство по эксплуатации (2 страниц), Краткое руководство по эксплуатации (2 страниц), Краткое руководство по эксплуатации (2 страниц)

2. For a self-powered hub, plug the wall mounted power supply (provided) into an AC power receptacle provid-

ing power in the range, 100 V–240 V, 50 or 60 Hz. Connect the power supply's plug (5 V) to the hub's 'DC

SUPPLY' jack.

3. Determine if the hub design will operate with internal regulator or external regulator and set the switch SW1

accordingly.

4. To enable I

5. The Blaster utility is used for in-system programming of I

as part of the DVK after installation, at the following location:

CY4608: C:\Cypress\USB\CY4608-HX2VL\1.0\Software

CY4608M: C:\Cypress\USB\CY4608M-HX2VL\1.0\Software

Note The path may vary based on installation.

6. To connect to the PC, plug a USB A-B cable (provided) into the hub's 'UP STREAM' connector. Plug the

other end of the cable into one of the PC's host controller ports. If the hub is plugged into a Full-Speed port

on the host controller, the hub will operate at full speed.

7. The hub is a 4-port hub. It is now ready for any Low-Speed, Full-Speed, or High-Speed devices to be

plugged into any and all of the ports.

1.5

Set Up the HX2VL CY4607/CY4607M Hardware

Due to the hot-plug nature of USB, hardware setup is easy.

Figure 1-2

CY7C65632. Determine if the hub design is a bus-powered or self-powered hub. A bus-powered hub does

not require any change.

Figure 1-2. CY4607M

HX2VL™ Development Kit Guide, Doc. # 001-73960 Rev. *C

C EEPROM, set J5 (place jumper).

shows the CY4607M, based on the 48-TQFP of CY7C65642; CY4607 is based on 48-TQFP of

C EEPROM (using USB requests). It is available

Getting Started