Cypress CM-390 Руководство по эксплуатации - Страница 3
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Компьютерное оборудование Cypress CM-390. Cypress CM-390 6 страниц. Cv/sv/pc/hd/hdmi 1080p scaler box
Также для Cypress CM-390: Руководство по эксплуатации (16 страниц)
Печатать страницу
(4). Operation Controls and Functions
Front Panel
1. Power button and LED indicator:
Press the button once to power on the unit, Press again to power off.
when the unit is powered on, one of the input LEDs will illuminate depending
on your last selection of input source before power off.
The factory default setting for the input is CV (composite video).
The green LED illuminates when composite video is selected.
The Yellow LED illuminates when S-Video is selected.
2. Input select button:
Press the button to select your desired input source between composite
video and S-Video.
3. IR Sensor: Infrad remote control sensor.
4. Menu/Enter: This button serves two purposes.
a. Press the button to enter OSD main control menu as shown in the "OSD Operation".
b. To act as a "enter" key to enter sub menu of your selected item.
5/6. +/- button: Press the button to move up or down the tick V to your
desired parameter. Or after a parameter is selected, Press the button to alter
the value of your selected parameter.
Rear Panel
1. DC power jack: 5V 2A DC power input.
2. Composite Video: Use a Composite video cable to connect the
composite video output of the source equipment to this composite
video(CV) input of the scaler.
3. S-Video: Use a S-Video cable to connect the S-Video output of the
source video equipment to this " S-Video" input on the back of the video Scaler.
S-Video provides improved performance over composite video and is
recommended over composite.
4. PC/HD output: This HD-15 D-Sub connector is shared by PC/RGBHV output
When PC/RGBHV output resolution (VGA to SXGA) is selected,
use the HD-15 to HD-15 VGA cable to connect this output to the PC input
of your display monitor.
When HDTV/YPbPr output (480p, 576p, 720p, 1080i) is selected,
use the HD-15 to YPbPr 3 x RCA cable to connect this output to
the YPbPr input of you HDTV display.
Note: Use of wrong cable for your selected output will result in an abnormal
picture on the screen.
POWER
INPUT
CV
SV
1
2
VGA OUTPUT
4
and HDTV/YPbPr output.
MENU
CM-390 Video to PC/HD Scaler Box
3
4
5
INPUT
SV
3
2
6
DC 5V 2A
CV
2
1