Ashly RW-8C Брошюра и технические характеристики

Просмотреть онлайн или скачать pdf Брошюра и технические характеристики для Пульт дистанционного управления Ashly RW-8C. Ashly RW-8C 2 страницы. Remote level control
Также для Ashly RW-8C: Руководство по эксплуатации (4 страниц), Краткое руководство по эксплуатации (4 страниц)

RD-8C, RW-8C Remote Level Control

Introduction: The RD-8C and RW-8C are remote level controllers which can be used with the

Ashly VCM-88C, as well as ethernet based Ashly NE signal processors, NE power amplifiers with

DSP capabilities, and Pema amplifiers. The RD-8C is a desktop controller using an XLR data con-

nector, while the RW-8C is electronically the same but mounts as a wall plate into a standard 4-gang

electrical box and uses a euroblock con nec-

tor. There are eight channel faders and

one master fader on the RD-8C, each with

a level control and an on/off button with a

green LED to indicate status.

Used with the VCM-88C, the RD/

RW-8C offers a direct correlation of remote

faders to VCM-88C channels, as well as its

master fader. Connect the RD-8C or RW-8C to a VCM-88C as illustrated above.

Channel 1 on a RD/RW-8C will always

control channel 1 on the VCM-88C, and like-

wise channels 2-8 and the master will each

control their respective VCM-88C channel. The

data output signal may be "split" in order to

feed two VCM-88C units to give stereo 8-chan-

nel capability. A Remote Disabled LED indi-

cates when the RD/RW-8C has been disabled

by the VCM-88C front panel switch. This LED

is inactive when the RD-8C is used with NE

products.

Used with Ashly NE products, assuming

they have DSP capabilities, each RD/RW-8C

slide fader can be assigned in Protea NE Soft-

ware as a remote level control tool for one or

several inputs or outputs. Only one RD/RW-8C

can be used per NE device, and no other serial

communications devices, including the WR-5,

can be used when an RD-8C is connected to

the data port. Connect the RD-8C or RW-8C to NE products as illustrated above.