Ashly XR-1001 Руководство по эксплуатации - Страница 5

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Кроссовер Ashly XR-1001. Ashly XR-1001 8 страниц. Electronic crossover
Также для Ashly XR-1001: Руководство по эксплуатации (13 страниц), Брошюра (1 страниц), Руководство по эксплуатации (16 страниц), Технические примечания и спецификации (2 страниц)

Operator Manual – XR Series Crossovers

XR-1001 Back Panel

1. Inputs - For unbalanced inputs, the signal should be on the (+) connection and the (-) connection tied to ground. A

mono 1/4" plug used as an unbalanced connection will automatically be grounded. When using a stereo plug, or XLR

connector for an unbalanced signal, the (-) input connection MUST be tied to ground.

2. Balanced Outputs - This output circuit is an active output which maintains a constant output level between the (+) and

(-) output terminals, regardless of either terminal being connected to ground. This servo-balanced output provides an

unchanged signal without regard to ground.

3. Power – Switches the unit power on or off.

Installation

Before connecting to mains power, make sure that the switches are set to the configuration

needed for your particular application. Always switch the crossover off before making

substantial changes to the settings, especially the Range. Failure to do so could result in

damage to the unit or other components in your system. Use four screws and washers when

rack mounting. For mobile use, the unit should be further secured as appropriate.

XR Crossovers have specific physical, electrical and signal requirements for proper

operation. These requirements will vary depending on your specific application, setup, and

the settings on the unit. When setting up and testing your system, please take special care

to double check all connections and settings. Please refer to the specifications section of

this manual for specific input, output and other figures.

AC Power

Your XR Crossover should be connected to a standard 3-wire grounded electrical outlet

supplying 100-240 Volts, 50-60 Hz. To reduce the risk of ground loop hum, connect all

audio equipment to the same electrical power source. Do not remove the AC plug ground

pin, as a potential shock hazard could result.

This unit will perform normally within the AC voltage range specified above. Voltages

less than this, as found in "brown-out" conditions, may reduce performance. No user

serviceable parts are inside the chassis. Refer all servicing to qualified service personnel.

Overall power consumption is less than 30 watts.

NOTE: The power switch does NOT isolate the appliance from mains. Make sure the mains

power socket or an alternative disconnect device is near by and easily accessible. When the

product is connected to mains, the line-filter and the input of the fuse are energized.

Page - 5

Introduction - 2

XR Crossovers – 3

Connectors & Cables – 3

Physical Description - 4

Installation – 5

General Requirements

AC Power

Typical Applications - 6

Troubleshooting - 7

Dimensions - 7

Specifications - 8

Warranty - 9