ACR Electronics AEROFIX 406 GPS I P-ELT - REV E Руководство по поддержке продукта - Страница 11

Просмотреть онлайн или скачать pdf Руководство по поддержке продукта для GPS ACR Electronics AEROFIX 406 GPS I P-ELT - REV E. ACR Electronics AEROFIX 406 GPS I P-ELT - REV E 17 страниц. Personal locator beacon fcc type approval is currently pending
Также для ACR Electronics AEROFIX 406 GPS I P-ELT - REV E: Руководство по поддержке продукта (17 страниц), Руководство по поддержке продукта (17 страниц), Руководство по поддержке продукта (17 страниц), Руководство по поддержке продукта (17 страниц), Руководство по поддержке продукта (14 страниц)

To secure antenna when the holster is on your TerraFix™, be sure to deploy antenna prior to placing the holster onto

the unit. Slide the antenna through the holster to secure it to the beacon. The holster will clip together at the bottom

of holster. Rotate antenna into down position in order to wrap it around the holster to lock it in place. Make sure the

antenna runs between the two guides on the bottom of the holster. This will prevent the antenna from slipping out of

position. Finally lock the antenna into place by engaging the tab located on the antenna into the slot provided on the

To Open the Holster, squeeze inward on the two tabs located on the bottom clip and pull up on the top of the

SECTION 6 - CARE AND MAINTENANCE

6.1

Carefully inspect the PLB case and gasket for any visible cracks. Cracks may admit moisture, which

could cause a malfunction. In the event of any cracking or structural damage, the PLB should be

immediately sent to ACR for evaluation and repairs, (1-800-432-0227).

6.2

Do Not clean your PLB with household cleaners and hydrocarbon materials such as gasoline,

benzene, bleach, sanitizers, soaps, etc., simply wipe your PLB down with a damp cloth until clean.

top right corner of the holster. Slide it in to lock in place.

holster. Rotate antenna up, and slide the holster off around the antenna.

Figure 8.

Removable Holster

Y1-03-0174 Rev. E