Akron Brass 3406 Краткое руководство по эксплуатации
Просмотреть онлайн или скачать pdf Краткое руководство по эксплуатации для Противопожарное оборудование Akron Brass 3406. Akron Brass 3406 7 страниц. Electric riser
Печатать страницуThe following is intended to provide the basic instructions for installation, operation and maintenance of the Electric
Riser, and to assist in attaining the best possible performance from the unit. Read and understand these operating
instructions before use.
TOOLS REQUIRED
• Utility Knife
• Medium Phillips screwdriver
• Small Phillips screwdriver
• Deutsch crimp tool (P/N HDT-48-00)
• Electrician's pliers (multipurpose, stripping and crimping)
PRODUCT RATINGS
Maximum Motor Current Draw:
12 volt versions
24 volt versions
Normal Operating Current: (Depending on operating conditions–pressure, flow, etc.)
12 volt versions
24 volt versions
Minimum Voltage: (Truck engine must be operating for proper voltage requirement.)
All 12 volt motors: 11.5 volts while operating
All 24 volt motors: 23 volts while operating
Maximum Flow: 1250 gpm (4800 lpm)
Maximum Pressure: 250 psi (17 bar)
PRODUCT WARNINGS
WARNING: For fire fighting use only by trained fire fighters.
!
WARNING: Charge the unit slowly. Rapid charging may cause a pressure surge that has the potential to cause an
!
injury, or damage riser and/or the monitor.
WARNING: DO NOT stow or deploy the Riser/Monitor while flowing. Pressing the stow or deploy
!
buttons causes the nozzle to move automatically and the water stream may cause damage to equipment
or injury to personnel.
WARNING: Aim the unit in a safe direction before pumping water through it. (e.g. away from power lines)
!
WARNING: Although the logic circuit board includes a water-resistant coating, it is important to keep water out of
!
the control box and logic box. Prolonged exposure to water will cause damage. When the cover of the
control box or logic box is removed, check that the gasket under the cover is intact and free of dirt and
debris.
WARNING: Do not use the electric controls when the override cranks are being used or are in position for use.
!
WARNING: Make the connection of the vehicle battery the final step.
!
WARNING: Replace the identification tags if they should become worn or damaged.
!
WARNING: DO NOT exceed the maximum pressure or flow ratings of the riser. Exceeding these ratings may lead
!
to an injury or may cause damage to the monitor.
WARNING: DO NOT install shutoffs on the outlet of the electric monitor. Shutoffs increase the potential
!
for pressure surges due to water hammer, which have the potential to cause an injury or damage the
riser and/or monitor.
WARNING: Riser may extend if water pressure is applied prior to deploying the assembly.
!
STYLE 3406 ELECTRIC RISER
• Medium flat screwdriver
• Small flat screwdriver
• 3/4 inch hex head wrench
22 amps
11 amps
17 amps
8.5 amps
121700