Dolphin KEYTS310 Руководство - Страница 2
Просмотреть онлайн или скачать pdf Руководство для Клавиатура Dolphin KEYTS310. Dolphin KEYTS310 2 страницы. Dolphin keyts300; keyts310 wireless garage door keypad dual frequency 300/310 mhz
Печатать страницу3
a. Remove the access door on the top back of the keypad by sliding the door
in the direction of the arrow. (see Figure 1)
b. Locate the frequency switches on the top of the electronic board located
inside of the access door. (see Figure 2)
3. SET FREQUENCY JUMPER
a. Determine the operating frequency you will use on your keypad installation.
This keypad can operate at either 300 MHz or 310 MHz. At 300 MHz the keypad is
compatible with the Hive 300/310 receiver and all 300 MHz receivers with 10 dip
switches. At 310 MHz the keypad is compatible with the Hive 300/310 receiver,
and all 310 MHz receivers with 8 dip switches and 310 MHz receivers with 10 dip
switches. (see S1 and S2 on Figure 3)
Figure 1
Back of
Keypad
access
door
Figure 2
dip
310MHz
switch
selection
300MHz
jumper
S2
8 dip
S2
10 dip
S1
Figure 3
300 MHz
- (10 dip switch)
jumper
in place
S1
S2
310 MHz
- (8 dip switch)
S1
S2
310 MHz
- (10 dip switch)
S1
S2
3
4. SET DIP SWITCHES
a. Set the DIP switches of the keypad to match the DIP switch settings of the
receiver, or a functioning transmitter. (see Figure 4)
b. Enter
then the 4 digit PIN on the keypad, and then press # to activate the
receiver. If you just purchased the keypad, the factory default 4-digit PIN is 1234.
So please enter 1-2-3-4 #. If the receiver does not operate, reverse the keypad
DIP switches, and re-enter
1-2-3-4 #.
HINT: When you enter the correct code followed by #, the keypad LEDs flash slowly
for 5 seconds. If you enter an incorrect code, the keypad LED will glow steady for
5 seconds.
Figure 4
S1
c. To change the 4 digit PIN (example)
#
#
1-2-3-4
(Old Pin)
followed within 5 seconds by
HINT: When you have entered the programming mode of # # the small LED glows
a steady red. When you complete the change of the PIN the small LED flashes
twice quickly.
To reset the keypad to the factory default code, remove the 9 volt battery and
depress and hold any key on the keypad, then reinstall the battery. Continue holding
the key down for 5 seconds and then release the key. The keypad is now reset to
the factory defaults.
4
Position the keypad on the garage door frame with the provided screws.
Lift up the conver and insert the long screw above the keypad in the slot
provided (a).
Remove the battery conver and insert the second long screw in the
lower slot (b).
Replace the battery cover.
Back
Opening
dip
switches
S2
1-3-5-7
#
(New PIN)
pin must be four digits
cover