ACR Electronics Satellite2 406 Руководство по поддержке продукта - Страница 10
Просмотреть онлайн или скачать pdf Руководство по поддержке продукта для GPS ACR Electronics Satellite2 406. ACR Electronics Satellite2 406 20 страниц. Emergency position indicating radio beacon
Печатать страницу4.4
Manual Activation Without Deployment
4.4.1
The Satellite
™ 406 and RapidFix™ 406 can be activated while still in its bracket by placing the thumb
2
switch in the ON position. Activation by this method overrides all sensors and turns the beacon "ON".
The caution note above still applies.
4.5
Deactivation
4.5.1
The Satellite
™ 406 and RapidFix™ 406 can be deactivated by:
2
If manually activated:
1) Returning the thumb switch to the "OFF" position.
If automatically activated:
1) Removing the beacon from the water. The beacon normally takes up to 12 seconds to deactivate, or
2) Placing the beacon back into the release bracket.
4.5.2
If the beacon continues to operate after it has been deactivated, remove the four screws holding the unit
together and unplug the battery to disable the unit. Return it to a Service Center for repair.
4.6
Full Functional Self Test
Please read all instructions before performing any of the tests. Be prepared to record data from the test.
4.6.1
The Satellite
™ 406 and RapidFix™ 406 can be tested in or out of the release bracket. A Self Test is
2
initiated by lifting the thumb switch to a vertical position and holding it in this position for at least one
second. The initiation of the test is indicated by a beep and the simultaneous lighting of the green and red
LED's.
The sequence of tests is:
1. Check Data Integrity ....................................... Beep and lights up Red and Green LEDs if passed
............................................................................. Stop if failed
2. Check 406 MHz Synthesizer .......................... Beep and lights up Red and Green LEDs if passed
........................................................................... Stop if failed
3. Check RF Power/Battery ................................ Beep and lights up Red and Green LEDs if passed
........................................................................... Stop if failed
4. Turn on green LED to indicate Successful Test.
5. Flash Strobe Light to test Strobe.
If all of the above occurs, the test has been successful.
NOTE: The homing beacon at 121.5 MHz is inhibited during self test.
4.6.2
It is strongly recommended to test the Satellite
™ 406 and RapidFix™ 406 on a Monthly basis.
2
7
Y1-03-0148 Rev. F