DRAIN CONNECTIONS
ASKO provides a 7/8" (22 mm) corregated drain hose
which is connected to the back of the unit to form a high
loop. If additional drain hose is needed, please
purchase an additional ASKO drain hose and joint it to
the provided hose with a 7/8" (22 mm)copper tube.
NOTE: Do not use any fittings anywhere in the drain
line that are less than 7/8" (22 mm) ID.
The access hole for the drain line should be 1-1/2" (38 mm).
The end of the drain line is 1/2" (12
mm), but it is adjustable to 7/8", 3/4",
5/8" (22mm, 19 mm, and 16 mm). If
the drain connection is larger than
1/2" (12 mm), you can easily cut the
drain line to fit the connection.
The illustrations to the right show three ways to connect
the drain supply line.
THE HIGH LOOP
The high loop is necessary for
proper draining. Therefore, all
ASKO dishwashers have the drain
hoses attached to the drain pump
and fastened to the top back of the
unit, as illustrated. This gives the
drain hose an automatic high loop,
which is necessary for proper draining. The drain hose
is fastened at the best high loop height with a plastic
zip tie. To eliminate potential drain problems, simply
leave this hose in place.
IMPORTANT THINGS TO
REMEMBER:
♦
Failure to provide the proper drain connection height
(minimum of 20" (508 mm) above the bottom of the
dishwasher base) or a 20" (508 mm) high loop will
result in improper drainage, which will damage the
machine.
♦
No part of the drain hose should be higher than 35"
(889 mm) from the bottom of the dishwasher.
♦
The hose must not be drawn straight to a floor well
or its equivalent because it might function as a
siphon and empty the machine.
♦
The drain hose can be extended to a maximum length
of 10 feet (3048 mm). Joints and jointed tubes, if any,
must have a minimum 7/8" (22 mm) ID.
♦
If the drain line is going to be connected to a waste
disposer, be sure to remove the knockout or plug
from the fitting on the disposer before connecting
the drain line.
♦
Do not use fittings smaller than 7/8" (22 mm);
otherwise the water may not drain properly.
When the installation is ready, open the supply valve
and let the pressure act for a while. Then check that all
connections are tight and there are no leaks.
THREE WAYS TO INSTALL
DRAIN CONNECTIONS
A.) Typical connection to sink plumbing before
trap (high loop drain)
B.) Connection to air gap then to the trap
C.) Connection to waste disposer with air gap
NOTE:
Don't forget to remove the knockout
or plug from the disposer fitting.
Page 5
Печатать страницу