Asko D1996HNDL Руководство по планированию и проектированию - Страница 6

Просмотреть онлайн или скачать pdf Руководство по планированию и проектированию для Кухонная техника Asko D1996HNDL. Asko D1996HNDL 15 страниц. Standard dishwashers
Также для Asko D1996HNDL: Руководство по эксплуатации и уходу (12 страниц), Установка и настройка (4 страниц), Руководство по планированию и проектированию (19 страниц), Руководство по эксплуатации и уходу (12 страниц)

Печатать страницу

CHANGING THE STANDARD FRONT PANELS

The front panels on Models D1706, D1716, D1776 and D1976

(except the stainless steel models) can be replaced with wood

panels.

PANEL DIMENSIONS

For standard, non-raised panels, use 1/16" to 1/4" material. For

custom raised panels, the decor trim will accept up to 1/4" flange.

The raised panel can be mounted on a backing sheet cut to fit as

shown on the right.

NOTE: The stainless steel panels do not have holes for custom

trim. You have to drill the holes.

INSTALLING THE PANEL

WARNING! Before working on any electrical appliance,

be sure the electrical power has been turned off at the

breaker/fuse box.

Refer to the illustration at bottom right for instruction references.

1. Remove the lower access panel with standard or 20 torx

screwdriver.

2. Carefully remove the plastic plugs around the edges of the

access panel and upper door panel. You may discard the

plugs.

3. Using the screws provided with the trim kit, loosely secure

parts A and C to the upper door panel.

4. Slide the upper panel into the trim kit grooves.

5. Tighten the screws holding parts A and C.

6. Secure part B and tighten screws.

7. Loosely screw part E to the lower access panel.

8. Slide the custom panel into trim kit channels and tighten the

screw to part E.

9. Secure part D of the trim kit and tighten the screws.

10. Secure the lower access panel to the dishwasher.

11. Drop the lower access panel to line up with the lower holes

on the guard plate and secure the screws. (Make sure the

exhaust vent is below the panel. Otherwise, steam from the

vent could eventually damage the panel.)

12. Before you push the dishwasher into the cabinet opening,

test the door to make sure it opens properly, (The door is

counter-balanced, so it should remain in any position.) If it

doesn't, you may need to adjust the door springs (see page 8).

13. Fasten the dishwasher to the cabinet.

Specifications are subject to change without notice. See installation instructions for additional details.

ASKO D

Upper Panel

25 mm

Raised area

2-1/4"

57 mm

23-3/16"

589 mm

Lower Panel

25 mm

2-3/16"

Raised area

56 mm

25 mm

23-3/16"

589 mm

1/4" PANEL TRIM KIT

ISHWASHER

25 mm

21-3/16"

538 mm

25 mm

4-3/16"

106 mm

21-3/16"

538 mm

Trim kit part numbers:

White: 8070850-0

Black: 8070850-29