ACR Electronics ACR-100 Ürün Destek Kılavuzu - Sayfa 9

Aksesuarlar ACR Electronics ACR-100 için çevrimiçi göz atın veya pdf Ürün Destek Kılavuzu indirin. ACR Electronics ACR-100 15 sayfaları. Field programmer reader

Sayfayı Yazdır

1. Programming

5. When the interface box is ready there will be a small message box that appears with

the information to put the unit into test mode after clicking OK. Click the OK

button.

6. There will now be a box that appears for approximately 60 seconds with green text

that says waiting for a test burst. At this point put the unit into test mode according to

the manufacturer's directions.

7. Once the message has been sent back to the PC, the PC screen will display the

verification report. When done viewing click the button at the bottom of the page. If

there is no message sent within 60 seconds there will be a message that signals the

test has timed out. If this happens go back to step 4 of this section and continue

forward.

8. There are also options to save a report and add text to the report. By clicking on the

button Add Text you can add up to three lines of text on the report. This text will be

placed after the last line of the report.

You can also save a report by clicking on the Save Report button. In the box

provided enter a name or path of the report you would like to save. If you do not

choose this option the report will not be saved. All reports are saved by their

hexadecimal ID code to the C:\FPR100\Reports directory unless otherwise specified.

For example, if you self-test a beacon that has the hexadecimal identification of

ADCD02019100401,

C:\FPR100\Reports\ADCD0219100401.ver.

However, you can customize saving the report. For example, if you wish to save a

report for the vessel Sara II to the a: drive you can enter in the text box a:\sara2.ver

If you wish to recall the saved report it can be viewed using the FPR-100 Report

Viewer. This program is available through the ACR website.

9. Refer to Figure 4 for a sample self-test report.

5.4

Printing a Self-Test Verification Report

1. Perform the Verify Self-Test Message as described in section 5.3.3.

2. On the Option Selection Menu click the Print Verify Report button. The program

uses the printer that is set up as your default Windows printer. If the FPR-100 does

not detect a printer set up on your computer there will be an indication on the screen

with a message box. If this occurs check your printer setup in your Windows™

operating system. If you have verified that your printer is set up correctly contact

ACR Electronics for more information.

the

program

would

save

the

file

Y1-03-0149 Rev. D