Ambirad AMBITEC PLUS Manuel - Sayfa 9

Kontrol Paneli Ambirad AMBITEC PLUS için çevrimiçi göz atın veya pdf Manuel indirin. Ambirad AMBITEC PLUS 11 sayfaları. Energy saving electronic control panel

Sayfayı Yazdır

Gas modulating output

Calculated from Set/Temperature -

Actual/Temperature.

0 - 5V output has a constant 1 volt supply

when there is no call for heat therefore the

GM44 (or other interface type) should be set

up to drop out at a voltage slightly above

this level.

For the Ambi-Rad Technical Department

telephone 01384 489700.

Before phoning it might be advisable to try

the following points:

If after installing the LCD display is blank

and the connections are correct the

AmbiTec Plus could need resetting this is

detailed below under clearing all settings.

Note The AmbiTec Plus control panel is fully

compatible with the MK2 Energy Mizor but

cannot be integrated with older style Energy

Mizor Master/Slave units.

Clearing password and/or setting's is

achieved by the following instructions

(Remove this part of the page if security of

operation is important.

To clear all settings in the panel, turn OFF

the power and re-instate whilst holdings

the

and the Select button.

To clear only the passwords, turn off the

power and re-instate whilst holding the

7 7