AMC iA240X Kullanıcı Kılavuzu - Sayfa 8

Amplifikatör AMC iA240X için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. AMC iA240X 13 sayfaları.

Operation

Rear panel operation

GROUND LIFT SWITCH

To eliminate a ground loop, set ground switch to FLOAT position and otherwise

to connect a ground to amplifiers chassis.

INPUT GAIN CONTROL

This control allows you to precisely adjust the input level of the signal arriving

at the rear-panel input connectors. At their fully counterclockwise position, the

signal is attenuated by -80 dB. At their fully clockwise position, the signal is no

attenuated. When 0dBu of signal arrives at the input and the input level controls

are set to their fully clockwise position (0dBu), the Amplifier delivers full power.

HP FILTER SWITCH

HPF reduce low frequency in audio signal.

COOLING VENTS

Cool air is pulled in through the front panel fan filters and eliminated through

the rear panel vents.

BALANCED XLR INPUT

Connect audio signal to electronically balanced XLR. Please note that the

iA240X iA360X needs at least 0 dBu to achieve maximum power.

USER MANUAL

iA240X/iA360X Power amplifier

LINK OUTPUT

Connect outgoing audio signal from balanced XLR connectors to additional

amplifier. Input and link connectors are connected with each other directly.

LINK FOR DC 24V POWER SUPPLY

This connector is designed to link the DC 24V power to additional amplifier. DC

IN and DC LINK connectors are connected with each other directly, inside the

amplifier.

INPUT FOR DC 24V POWER SUPPLY

This connector is designed to power up amplifier when the main power is un-

available. Use only 24V power supply or batteries and take attention to polarity

during the wiring. If both, AC and DC power are connected, amplifier will use

main AC power.

PHOENIX OUTPUT

Use this connector to connect amplifier to the loudspeakers.

AC FUSE HOLDER

Please use 3,15A, 250V fuse for amplifier iA240X and 4A, 250V fuse for amplifier

iA360X

MAIN POWER CONNECTOR

Power connector is designed for main powers connecting to amplifier. This

connector is combined with fuse holder.