AMC MA 120 Kullanıcı Kılavuzu - Sayfa 6

Amplifikatör AMC MA 120 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. AMC MA 120 8 sayfaları. Mixing amplifier
Ayrıca AMC MA 120 için: Kullanıcı Kılavuzu (9 sayfalar), Kullanıcı Kılavuzu (12 sayfalar), Kullanıcı Kılavuzu (13 sayfalar)

Sayfayı Yazdır

Microphone Connection

Mic1~5 inputs are balanced standard XLR

Jack, rear panel. Mic1 input has VOX priority which

will override Channel 3 to 6 and Line input signals,

channel 2 will not be overridden.

Line (Aux/CD) Connection

The equipment provides an auxiliary input which may be used for connecting other signal

Sources such as a Radio Tuner, CD or Cassette player. A Slide switch is located on the read

panel for selection of Mic3 or Tel, Mic4 or Aux4, Mic5 or Aux5.

The line level Control operates on each of the input sources independently.

To operate select the desired music source using the slide switch and turn the "Channel" control

Clockwise to increase the volume or anticlockwise to reduce the volume.

The Aux / input sockets are standard stereo RCA connectors, single sockets are supplied and these are linked

together internally, this allows stereo signal source to be used without the need to obtain a special lead. However

you may wish to check with the manufacturer of the signal source to ensure that no damage will result if the left

and right output channels are put in parallel.

Tape Output Connection

These standard RCA Stereo sockets provide a mixed output suitable for connecting a tape or cassette recorder.

Aux out

Connects the mixer/preamplifier stage to the power amplifier stage. The connecting link must be plugged in for

normal operation as a mixer/amplifier. "AUX OUT" signal is affected by the tone controls and the master volume

control.

Power outline voltage complies with power input voltage (IEC voltage).

Loudspeaker Connection

Note: Use only 100V or 70V (Selectable) Line Loudspeakers

Low Impedance (8 )

utput allows connection of standard low impedance loudspeakers, the minimum load impedance must be

8Ω.

Connecting a Mixer Amplifier to a Power Amplifier

This amplifier can be connected using RCA to RCA leads from the mixer amplifier PRE out the power amplifier

input RCA socket. Further power amplifier can be connected by connecting from the output of first power

amplifier to the input of the second. Up to three power amplifier can be connected in this way.

Input must be from power amp in (Rear Panel) (Mic1 XLR Jack)