AMC SRL400/R Montajcı Kılavuzu - Sayfa 3
Güvenlik Sensörleri AMC SRL400/R için çevrimiçi göz atın veya pdf Montajcı Kılavuzu indirin. AMC SRL400/R 6 sayfaları. Two-way radio buzzer kit for r400 series control units
Sayfayı YazdırThe buzzer board features 2 signaling LED, a battery connector and 2 power supply terminals:
RED LED (POWER SUPPLY CHECK)
- Off: the buzzer is not powered
- Brief flash every 4 seconds: in standby operating mode
- Steady on: the battery is recharging
- Fast flash: the battery is not connected, is faulty or is dead
- Slow flash: recharging voltage missing
GREEN LED (RADIO PART SYSTEM AND CHECK):
- Steady on: no linked transmitter (buzzer not programmed)
- Steady on for 1 second: status transmitter toward CS400. (ALL OK)
- Fast flash for 1 second: control signal reception from CS400 (ALL OK)
- Slowly flashes during self-learning phase (see below)
CONNECTING THE POWER SUPPLY TERMINALS:
- Connect a power to the + - terminals (see figure) having an output voltage between 10 - 15 Vcc 200mA
POLARIZED BATTERY CONNECTOR:
- Connect the battery pack included in the buzzer package (TYPE Ni-MH 700mAh 7.2Vcc)
ASSEMBLY OF BUZZER SHELL AND ACCESSORIES
An installation according to standard requires the use of a screw fastened to a wall, whose head must exert pressure on the anti-
removal microswitch, located on the lower side of the board.
Note: bending the metal tab of the microswitch to achieve the same purpose nullifies the certification.
www.amcelettronica.com
SRL400/R V1.0 EN