AMCI SD17060B-03 Kullanıcı Kılavuzu - Sayfa 12
Servo Sürücüler AMCI SD17060B-03 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. AMCI SD17060B-03 20 sayfaları. Stepper drives
Sayfayı Yazdır
CONNECTING YOUR MOTOR
Compatible Motors
The SD17060B will work with many different motors, including those not sold by AMCI. This section
assumes that you have already chosen your motor and you are looking for wiring information. No wire colors
are given because there is no single industry wide color coding standard for stepper motor wires. You must
refer back to your motor data sheets for this information.
AMCI offers several different stepper motors in sizes 23 and 34. Refer to our website, www.amci.com, for
additional information on these products.
Motor Wiring
Eight Lead Series Connected
Six Lead Series Connected
B
B
A
A
Four Lead Connected
B
B
A
A
Refer to the torque vs. speed curves on your motor's
specifications sheet to determine if you should wire the
motor to the
configuration.
The two center tap pins on the drive are electrically isolated
and are for wiring convenience only.
Reversing the ±B connections will reverse the motor's
direction of rotation.
12
LEAD
MOTOR
LEAD
MOTOR
SD17060B
in series, parallel, or centertap
Eight Lead Parallel Connected
INTERLOCK
B CTAP
B
B
EARTH GND
A
A
A CTAP
INTERLOCK
Six Lead Center Tap Connected
6
B
B
A
A
4
ADVANCED MICRO CONTROLS INC.
1)
The Interlock jumper is a safety
device that is needed for proper
operation. The SD17060B will not
power the motor without this jumper.
When the jumper is installed,
up to 170Vdc is present on the
connector. Do not use the Interlock
for anything other than its
intended use as a safety device.
2)
3)
6
LEAD
MOTOR