Flocorp GUARDIAN 1000 G1 Kullanım Talimatları Kılavuzu - Sayfa 16

Ölçüm Cihazları Flocorp GUARDIAN 1000 G1 için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. Flocorp GUARDIAN 1000 G1 20 sayfaları. Wireless monitoring system

Sayfayı Yazdır

TROUBLE SHOOTING CONTINUED

Nothing happens when the Start switch is pressed.

Remove all of the batteries. Wait 30 seconds to initialize the Guardian memory and then reinsert the batteries. If

the green LED does not come on when the switch is pressed, replace the batteries with new ones.

Unit cannot transmit to data center.

Verify that the RSSI is greater than 20.

Verify that there is GSM SMS (Short Message Service) on the side selected in the carrier preference setting.

Check for interfering structures such as tanks, buildings, or large equipment.

Reposition the unit if possible.

Check that the antenna connection to the unit is tight.

Verify the Serial Number of the unit on the web site.

Use an external antenna.

The level reading is incorrect

Normally, all of the sensor parameters are set up by your FLO-CORP account representative when the tank is

initially configured. On rare occasions, the information may not be correctly entered. If you have verified the tank

information and the tank level is still incorrect, there may be several causes for the incorrect reading. If it is a

differential pressure sensor, verify the settings for the probe offset and the SGU. Either one of these settings may

cause the reading to be off. If this is a 4-20mA current loop sensor, verify the 4mA and 20mA settings. If either of

these settings is incorrect, then the level that is calculated from the sensor data will be wrong.

Verify the tank height.

The level reading is correct but volume is off

Verify the tank capacity. This should be the volume in the tank at the tank height. If the tank has a slight cone top

but a standard vertical strapping chart is used, then the tank height should be only to the shoulder of the tank.

Verify that the correct strapping chart is used.

The unit has stopped calling

Replace the batteries.

Ensure that the antenna is tight and vertical.

(877) 356-5463

(p) 330-331-7331

(f) 330-331-7172

www.FLO-CORP.com

REVA 1116