Flodin Works Flodin Modelwork Saab 29 Tunnan Manuel - Sayfa 8

Oyuncak Flodin Works Flodin Modelwork Saab 29 Tunnan için çevrimiçi göz atın veya pdf Manuel indirin. Flodin Works Flodin Modelwork Saab 29 Tunnan 11 sayfaları.

Sayfayı Yazdır

W1.3mf

2 WINGS

Cut away.

Start with cleaning the parts. Get rid of all the oozed plastic at the foot

of the print. Cut away the little parts at the end of the overlapping areas

(see image).

Glue together W1, W2 and W3. Use the 5mm carbon rod to align the

pieces. Make sure that the rod doesn't get glued.

Glue the aileron1 and aileron2. Use the 1mm carbon rod to align.

Same here... make sure that the rod doesn't get glued.

Align the aileron to the wing and push the 1mm carbon rod through

the hole in the aileron and in the hinge in the wing, all the way into the

hole in W1.

Glue W4 in place, aligning the carbon rod in the hole in W4. Make

sure that you don't glue the aileron to W4.

Glue the wing to the fuselage with the 5mm carbon spar.

CONNECTING THE SERVO

Screw the servo to the servo cover.

Put the wires in the channel in the wing.

Screw the servo cover to the wing.

J2 9 TUNNAN - MANUAL

W2.3mf

FL O DI N M ODEL W O RKS

aileron1.3mf

W3.3mf

Part

Material

LW-PLA

aileron1

LW-PLA

aileron2

LW-PLA

wing servo cover

PLA

wing servo cover left/right.3mf

aileron2.3mf

W4.3mf

Printer setting