AMD DiskOnChip Kullanıcı Kılavuzu - Sayfa 7

Anakart AMD DiskOnChip için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. AMD DiskOnChip 13 sayfaları.

AMD

Installing and Configuring the DiskOnChip PCI EVB

When installing the DiskOnChip PCI EVB as a bootable drive in operating systems other then DOS,

make sure to place the relevant systems files on the DiskOnChip (i.e., execute according to Section

5.1, then install the systems files and continue with Section 5.2).

In Windows systems, the "New hardware found" message is displayed each time you boot with the

PCI board plugged in. To suppress this message, choose to install a driver, and select the

DOC_PCI.INF file located in the 'PCI_EVB' directory of the DiskOnChip software utilities. This

will NOT install a driver but will inform Windows of the new hardware and stop this message from

being displayed at boot time.

When working with the EVB in environments other then PC, you must use the DiskOnChip BOOT

SDK to enable your boot code to access DiskOnChip and load your OS and drivers.

Additional information, scenarios and advice regarding use of the DiskOnChip as a bootable drive is

available in the DiskOnChip Software Utilities User Manual.

DOS example:

1. Mount DiskOnChip(s) on the EVB in the appropriate socket (SODIMM, DIP, TSOP).

2. Insert the EVB into a free PCI slot (make sure your host is powered OFF)

3. Power ON your computer (host).

Note: TSOP devices require formatting before proceeding to step 4 (refer to the DiskOnChip software utilities

manual on our web site).

4. You may now access the EVB as an additional drive.

When using other operating systems you may need to first install the DiskOnChip driver (see the

DiskOnChip OS-specific installation manuals).

The DiskOnChip EVB may be used either as an additional hard drive or as the system's boot device

(drive C:). When shipped, the default settings of the DiskOnChip cause it to be installed as the next

available drive. This will typically be drive D: if the system already includes another drive. To

convert it into a bootable DOS drive perform the following:

1. Boot the system and ensure that the DiskOnChip EVB is correctly installed as an additional drive.

2. Copy your system files onto the DiskOnChip:

FORMAT D: /S

1. Remove your hard drive or type:

DFORMAT D: (or /WIN:segment) /FIRST /S:DOCnn.EXB /UPDATE

a) The

flag must be used when the

DiskOnChip firmware file name.

DiskOnChip and TrueFFS are M-Systems registered trademarks.

(assuming DiskOnChip is registered as drive D:).

SYS D:

flag is used.

/FIRST

DiskOnChip PCI EVB User Manual

stands for the

DOCnn.EXB