AMD DIrect FPB-25SFPSSF18TPSI-N Kurulum ve Kullanım Talimatları Kılavuzu - Sayfa 11

Dış Mekan Şömine AMD DIrect FPB-25SFPSSF18TPSI-N için çevrimiçi göz atın veya pdf Kurulum ve Kullanım Talimatları Kılavuzu indirin. AMD DIrect FPB-25SFPSSF18TPSI-N 20 sayfaları. Square flat pan fire pits with thermocouple piloted safety ignition (tpsi) & pro brass snowflake burner

Sayfayı Yazdır

CAUTION: Children and adults should be alerted to the hazards on high surface temperatures and should stay away to

avoid burns or clothing ignition. Young children should be carefully supervised when they are in the area of the appliance.

WARNING: Do not use this appliance if any part has been under water. Immediately call a qualified service technician

to inspect the appliance and to replace any part of control system and any gas control, which has been under water.

1. Never leave the fire pit unattended during operation.

2. Clothing or other flammable materials should not be placed on or near the appliance.

3. Any guard or other protective device removed for servicing the appliance must be replaced prior to operating the

appliance.

4. Installation and repair should be done by a qualified service person. The appliance should be inspected before

use and at least annually by a qualified service person. More frequent cleaning may be required as necessary. It

is imperative the control compartment, burners and circulating air passageways of the appliance be kept clean.

5. Inspect the fuel supply connection before each use of the appliance.

6. Temporary storage of this appliance indoors is permissible only if it has been disconnected from its fuel supply

(Natural or L.P. gas line).

1. This appliance is hot when operated and can cause sever burns if contacted.

READ ALL LIGHTING INSTRUCTIONS BEFORE ATTEMPTING TO LIGHT FIRE PIT

CAUTION: ENSURE YOU HAVE LEAK TESTED THE FIRE PIT BEFORE OPERATING.

WARNING: Do not stand over fire pit during ignition or operation due to high surface temperatures.

LIGHTING INSTRUCTIONS

TURNING ON FIRE PIT

1. Depress and hold the red Piezo button and ensure sparking is occurring inside the pilot hood. An audible sparking

sound can be heard.

2. While holding the Piezo button, slightly depress the control knob inward and rotate counter clockwise to the PILOT

position. Depress and hold control knob inward for at least 30 to 60 seconds; to light the PILOT.

3. Once the pilot lights, release the Piezo button and turn control knob counter clockwise to the ON position. If pilot does

not stay lit, release the control knob, turn the control knob clockwise to turn OFF and wait 5 minutes before trying

again. Turn gas supply OFF to check ignitor spacing and Piezo battery if no sparking occurs.

4. Repeat steps 1-4 to try again.

TURNING OFF FIRE PIT

1. Slightly depress the control knob inward and rotate the knob clock wise to OFF position. Fire pit will turn OFF.

2. After cooling off install cover (if applicable).

Drop In & Flat Pan Fire Pits with Snowflake Burner and (TPSI) Ignition

OPERATION

SAFETY WARNINGS

WARNING

2. Do not burn any solid fuels in this appliance.

Fig. 11 Control panel with gas valve knob and Piezo.

PILOT

OFF

Control Knob

Piezo Button

REV. A

Page 11