AME 92200 Kullanım Talimatları - Sayfa 2

Araçlar AME 92200 için çevrimiçi göz atın veya pdf Kullanım Talimatları indirin. AME 92200 5 sayfaları. Otr o-ring installer tool, up to 30" rims

Sayfayı Yazdır

! WARNING !

To avoid serious personal in-

jury, always wear proper pro-

tective gear, such as hard

hats, safety glasses, gloves,

and steel toe shoes when us-

ing hydraulic equipment.

Failure to chock the wheels

and crib the vehicle can re-

sult in Serious injury or

death. Always deflate tires

before removing a wheel, a

rim, or part of a rim clamp or

nut. If you do not deflate the

tire, the tire could explode,

causing serious injury of

death. Always stand to one

side of the rim when using

the bead breaker. Standing to

one side of the bead breaker

allows you to maintain con-

trol of the bead breaker. If it

is not seated properly and

flies off the rim, the bead

breaker could cause serious

injury or death.

AME INTERNATIONAL

OPERATING INSTRUCTIONS

Warning

This product as well as all tire tools should never be used by persons

unless they have been properly trained according to O.S.H.A. Regula-

tion #29CFR1910.177 entitled "Servicing Single-Piece and Multi-Piece

Rim Wheels."

Caution

BEFORE USING THIS TOOL READ INSTRUCTIONS THOROUGHLY.

THE USE OF THIS TOOL IN ANY OTHER APPLICATION IS BOTH A

VOID OF WARRANTY AND CAN LEAD TO INJURY OR EVEN DEATH.

Operating Instructions

After placing a bead flange as far inside the bead of the tire as possible,

do as follows to accomplish full installation of the tire onto wheel assem-

bly.

1. Place bottom cross bar, the bar with the two

black ends as seen in Figure 1, inside of the

wheel at twelve and six o'clock position.

Make sure the gripping plates are tight

against the inner bevel of the wheel, adjust

by loosening set bolts and sliding out until

the tighten set bolts, adjust bottom gripping

plate and then top, making sure it is cen-

tered as possible.

2. Hang the "O" Ring on the top set bolt of the

bottom cross bar so as out of the way until

installation of "O" Ring (See Figure 2).

3. Slide top cross bar assembly over the

threaded center rod at the nine and three

o'clock positions, so that the push bar lines

up against the rim flange. Adjust for the tire

diameter of the wheel by loosening and tight-

ening set bolts as needed (See Figure 3).

- 2 -