AME Intl. 13155 Kullanım Kılavuzu - Sayfa 4

Kaldırma Sistemleri AME Intl. 13155 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. AME Intl. 13155 5 sayfaları. 100 ton aluminum cylinder with locking collar

Sayfayı Yazdır



Always keep cylinder clean, use dust cap to protect coupler.



After finish work, Cylinder must be fully retracted, cleaned and stored in ventilation,

moist-proof, corrosion-proof place.

7. TROUBLE-SHOOTING

WARNING: AME International Cylinders should be repaired only by a qualified

operator or authorized AME International Service Center. Repair cylinders without

special tools and knowledge may result in personal injury. Please release pressure and

disconnect hose(s) before making repair.

Problem

1.Pump release valve open

2.Couplers not fully tightened

Cylinder

will

not

3.Oil level in pump reservoir is low

extend

fully

4.Pump or valve malfunctioning

extend

5.Overload for cylinder

6.Cylinder piston rod binding

1.Leaky connection

Cylinder can not

2.Cylinder seals leaking

maintain pressure

3.Release valve not fully closed

4.Pump or valve malfunctioning

1. Leaky connection

Cylinder

extends

2. Coupler not fully tightened

slower than normal

3. Pump malfunctioning

Cylinder extend in

1. Air in system

dithering

2. Cylinder piston rod binding

1. Leaky connection

Cylinder

leaks

2. Worn or damaged seals

hydraulic oil

3. Cylinder damage

AME INTERNATIONAL

Cause

Solution

1.Fully tighten pump release valve

2.Fully tighten couplers

3.Fill oil in pump

4.Repair or use another pump and valve

5.Change another cylinder with appropriate

capacity

6.Check for dirt or leaks, change the damage

parts

1.Clean and reseal thread, tighten connection

2. Replace worn seals. Clean inside cylinder and

use clean hydraulic oil

3. Fully tightening the release valve

4. Repair, or use another pump and valve

1.Clean and reseal thread, tighten connection

2. Fully tighten couplers

3. Repair or use another pump and valve

1. Bleeding air in the system

3. Check for dirt or leaks. Check for bent,

misaligned and worn parts

1.Clean and reseal thread, tighten connection

2.Replace worn seals, clean inside cylinder and

use clean hydraulic oil

3. Use new cylinder of contact with your nearest

Authorized AME International Hydraulic Service

Center.