CO2 Meter TR250Z Kullanıcı Kılavuzu - Sayfa 6

Aksesuarlar CO2 Meter TR250Z için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. CO2 Meter TR250Z 13 sayfaları. Oxygen sensor

TR250Z Oxygen Transmitter – Manual

Quick Start Guide

Make sure you read through these instructions thoroughly before using your meter. This guide will help

you familiarize with your meter in order to be as productive as you need to be in the least amount of

time possible.

Display – Main interface to view current sensor readings and menu state. Will blink "STRT" upon

applying power while the sensor warms up and stabilizes.

LEDs – are in for lower right corner of the unit on the main PCB and are labeled S, E and P.

S LED – Status LED. Blinks every time a complete measurement cycle is performed and the value is

updated. Serve's as a heartbeat for transmitter operation.

E LED – Error LED. Will light if any abnormal conditions are detected within the device, primarily the

sensor falling out of its recommended operating specifications will trigger this lamp.

P LED – Power LED. Will be on continuously when power is applied to the unit.

Buttons ‐ The unit has three surface mount buttons above the LEDs on the PCB. They can be gently and

carefully pressed with your finger. These buttons allow you to access all aspects of sensors operation

and test or calibrate different functional modules.

Rev. 27 April, 2015

Install DAS online (Internet Explorer 9 shown)

CO2Meter.com

Pg. 6 of 13