Co2meter CM-0003 Kullanıcı Kılavuzu - Sayfa 9
Veri Kaydediciler Co2meter CM-0003 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Co2meter CM-0003 17 sayfaları. Co2 sampling data logger
Sayfayı YazdırSampling Data Logger User's Manual
Quick Start Guide
IMPORTANT: M
AKE SURE TO INSTALL GASLAB SOFTWARE BEFORE CONNECTING YOUR METER TO YOUR COMPUTER
1. Install fresh set of AA batteries (Duracell brand recommended) or connect the included power supply.
2. Install filters and tubing included as shown on Figure 6 as required.
3. Turn the meter ON by pressing the power switch once.
4. Turn logging ON by pressing the LOG switch once. Once the sampling process is completed, data can be
downloaded to your computer using our GasLab
Powering the Meter
This meter can be powered by four (4) AA size batteries (not included) but sampling units can also be powered by
the included 6VDC international wall power supply. These units should NOT be powered using the included USB
cable since it supplies inconsistent voltage to the meter, which degrades sensor accuracy.
If the unit is not going to be used for an extended period of time, batteries should be removed to prevent damage
due to potential battery leakage.
The POWER switch
meter enables/disables data logging and pump function.
Operation
Make sure you read through these instructions thoroughly before using the meter. This guide will help you become
more familiar with the meter in order to be as productive as possible in a short period of time. Please read the
Important Safeguards on page 4 before continuing.
IMPORTANT: Follow these instructions to ensure proper set up:
1. Download the GasLab
2. Power the meter using the included universal power supply. Turn ON the meter.
3. Wait until the display changes colors to visually confirm it has reset successfully after connecting it to a
computer.
Connecting the Meter to your PC
The first time the meter is connected to your computer, the operating system will install the necessary USB drivers
as shown in Figure 3. This process could take a few minutes.
on the left side of the meter turns the unit ON/OFF. The LOG switch on the right side of the
software to your computer as shown in the GasLab
®
Figure 3: USB Driver Installation.
software.
®
CO2Meter.com
Software section on page 6.
®
PAGE 9 of 17
.