ACR STOVES PR-1200e Kullanım Talimatları Kılavuzu - Sayfa 12
Kapalı Şömine ACR STOVES PR-1200e için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. ACR STOVES PR-1200e 17 sayfaları. Electric fireplace insert range
Sayfayı Yazdır
SETTING THE COLOUR FUNCTIONS
• Press the lamp button
• Lamp 1 is for the rear flame
• Lamp 2 is for the base effect
• Lamp 3 is for the log effect
By pressing the lamp buttons, this will change
the colour of the rear flame, base effect and the
log effect separately.
SETTING THE TIME
• Press the CLOCK SETTING button which will
start the DAY curser to blink. Using the
CLOCK UP and CLOCK DOWN buttons to
set the current day e.g. 1-Monday, 2-Tuesday
etc and press CLOCK SETTING to confirm
the required day.
•The hour setting will now be blinking. Adjust
this by using the CLOCK UP and CLOCK
DOWN to reach the present hour and confirm
by pressing CLOCK SETTING.
•The minute setting will now be blinking. Adjust
as per the hour setting.
• Your smart phone / tablet must be
connected to WIFI and the insert plugged
in.
• Use the POWER SWITCH and an orange dot
should appear on the fire screen. Do not use
the STAND BY button to switch this on.
• Scan the QR code and
download the ACR
Stoves app
• Open the app and click
the SIGN UP button. If
you already have this
App installed for other
ACR electric products
then please log in using your existing details.
The App can be used to operate multiple
ACR electric products.
• Input your email address and the App will
send a verification code to your email
address.
• Input the code to create your password.
• Press the Add Device button to add your
device.
App Installation and Smart Control
12
ADJUSTING THE TEMPERATURE
While the insert is switched on, use
TEMPERATURE UP and TEMPERATURE
DOWN to set the required room temperature. A
confirmation beep will be audible from the fire.
If the room temperature is already warmer than
the temperature set on the remote control, the
heater will switch off / not come on until the
temperature in the room drops to below that on
the remote control.
ADAPTIVE CONTROL
This works in conjunction with the timer
programme. When Adaptive Control mode is
selected and turned on the fire monitors the
room temperature in relation to the selected
target temperature. If the room temperature is
lower than the selected temperature, the
Adaptive Control facility will instruct the fire to
switch on between 2 to 5 minutes earlier than
the set time this is to ensure that the room is at
the required temperate at the time selected
(please note this may not be possible to
achieve if the room is very large or very cold).