Coachsound TourMaster-Lite TML2500 Kurulum Kılavuzu - Sayfa 6
Sunucu Coachsound TourMaster-Lite TML2500 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Coachsound TourMaster-Lite TML2500 11 sayfaları. Two channel audio server
Ayrıca Coachsound TourMaster-Lite TML2500 için: Kullanıcı Kılavuzu (15 sayfalar)
Sayfayı Yazdır
TourMaster-Lite Installation Guide v2.0
This is the connection for the GPS aerial. The "LINK" indicator will blink once per second when the aerial is
operating correctly. If "LINK" does not blink, then there may be a fault with the aerial or cable. If the "POWER"
indicator goes out when connecting the aerial there is a fault with the aerial. Remove and check aerial cable and
aerial for faults.
•
GPS aerials with a yellow boot on the aerial cable will be compatible with this connection.
2.3.1 GPS Connection
NOTE: The default pin-out of the RJ45 connector on a GPS16x-HVS aerial that has NOT been
supplied by Coachsound will differ to the colour code shown above and must be rewired.
RS232 communication interface to NMEA 0183 standard GPS receiver. The Tourmaster-Lite system has
been tested to work with the Garmin GPS16x-HVS aerial. Other aerial brands/models are not tested nor
guaranteed. To determine proper communication between the system and GPS aerial, check that the LINK
indicator is blinking on the GPS port when the system is powered and operating.
Required aerial settings are:
1. 4800 baud rate
2. NMEA-0183 GPRMC sentence output (single sentence output)
3. With or without sentence checksum
2.4 AUX Port
This connection provides additional communications between this system and external devices such as
scrolling signs, ticketing machines, media servers etc. An application-specific firmware driver is required for
this port to be operational.
Figure 3: RJ45 Connections for Garmin GPS16x-HVS
5