Coalesse E-table 2 Manuel - Sayfa 10

İç Mekan Mobilyaları Coalesse E-table 2 için çevrimiçi göz atın veya pdf Manuel indirin. Coalesse E-table 2 15 sayfaları.

NOTE: Careful scheduling coordination of the various contractors involved in any E-Table 2 installation will simplify the process for all. At this

point it is recommended that the furniture installers "step aside" and allow the cabling installers to install communications cables. If this is not

practical, then the cabling installers will need to remove one or both side panels after the table is completely assembled. See page 13 for this

procedure.

VERY IMPORTANT!

Reattach Jumper Bracket.

9. Terminate all communication cables

Remove the blank faceplate covers. Pull through and terminate all voice/data cables using a

standard architectural single, double, or triple-gang faceplate.

There are numerous holes spaced along the top of the C-shaped beams that can be used as

tie-down points for data cables. DO NOT tie-down cables to the holes on the side or bottom of

the beams. These will be used to attach the side panels next.

Reinstall bottom cover

Reverse step 4.

Page 10 of 15

939500448 Rev E