Coalesse Lagunitas Kurulum Talimatları - Sayfa 2
İç Mekan Mobilyaları Coalesse Lagunitas için çevrimiçi göz atın veya pdf Kurulum Talimatları indirin. Coalesse Lagunitas 4 sayfaları. Corner screen replacement
Ayrıca Coalesse Lagunitas için: Manuel (3 sayfalar)
Sayfayı YazdırFABRIC SCREEN GANGING CLIP INSTALLATION
(The instructions on this page only apply if your unit has
upholstered screens. If your unit has mesh screens, please
continue to page 3)
WARNING: Ganging units using the screen ganging clip will
require creating a hole in the upholstery. This hole is only visible
if the units are separated.
NOTE: The screen ganging clip can only be used if the adjoining
screens are the same height.
Locate the end of the unit you wish to gang.
Measure down from the top of the screen and place a mark on
the welt cord at 4 inches.
Using pliers, carefully grab the welt cord and pull it slightly out of
the channel.
Using
,
marked in step 2. BE CAREFUL NOT TO CUT THE FABRIC ON
THE SCREEN! After cutting the welt cord, you should see a hole in
the screen. Trim a 1/2 inch from the welt cord, making sure the hole
will be accessible when the welt cord is tucked back into the
channel. NOTE: If the hole in the screen is covered by fabric, trim
the fabric away with scissors, so it doesn't prevent the ganging clip
from functioning properly.
Install the screen ganging clip (with the overlapping joint on top)
until a 'click' is heard and ensure the clip can't be pulled out from the
screen.
the welt cord at the line you've
4"
2
WELT
CORD
4
3
SCREEN
GANGING CLIP
5
OVERLAPPING
JOINT
Page 2 of 4
69925 Rev B