Coastal Paragon NEO ANGLE w/Bi-fold Manuel - Sayfa 5

Banyo Armatürleri Coastal Paragon NEO ANGLE w/Bi-fold için çevrimiçi göz atın veya pdf Manuel indirin. Coastal Paragon NEO ANGLE w/Bi-fold 8 sayfaları.

Sayfayı Yazdır

Trim Header Pieces

Before trimming Header pieces (b2 & b3), remember to add or

subtract any out of plumb discrepancies that might exist on the

corresponding walls (as measured at top of Wall Jambs).

Trim Header (B) pieces to measurements specified in step 1 (plus

or minus any out of plumb discrepancies).

Assemble and Position Header atop Verticals

Assemble Header (B) by inserting Corner Brackets (R) into Header

pieces and bringing the pieces together (see figure above and

exploded view - sheet 3).

Using the Corner Bracket holes as guides, mark and drill the Header

pieces with a 1/8" drill bit. Secure the Corner Brackets to the Header

pieces with eight(8) #6 x 1/4" machine screws (S). Position Header

atop verticals.

Secure Header

TO PREVENT GLASS BREAKAGE

SLIDE GLASS PANELS AWAY FROM WALL JAMBS BEFORE DRILLING HEADER

From interior, secure both ends of Header to Wall Jambs using one

638PHPT Installation Screw (T) at each end. To prevent glass break-

age when drilling the Header, temporarily slide glass panel away

from Wall Jambs. When done, re-center glass panels as before.

Insert Glazin Vinyls

Insert Vertical and Horizontal Glazing Vinyl (V & W) to secure the

Glass Panels (U) in place. Use a vinyl roller to speed up installation.

Trim top & bottom Dam Strips

Measure the door opening width at Sill and Header levels. Trim top

and bottom Guide Tracks (C)to measurements obtained. With high

lips toward exterior, position Guide Tracks on the Header and Sill

and snap them into place.

Install Strike Jamb

Determine which side you want your door to strike (left or right, your

choice). Once strike side has been determined, insert Strike Post

(F) into the appropriate Corner Jamb (E), magnet should be facing

toward exterior of enclosure, see exploded view - sheet 3.

Install Top and Bottom Bushings

Before proceeding with Door

Assembly installation, note

that the Door Assembly (G)

must always fold in toward in-

terior of shower enclosure

(see exploded view - sheet

3).

Position Door Assembly on

floor the way it will be in-

stalled on enclosure (remem-

ber, unit must fold into enclosure).

Install Pivot Bushings (M), Pivot Bushing Screws (N) and Slide Piece

Set Screws (L) onto top and bottom Slide Pieces (g6) as shown in

figure above and in exploded view - sheet 3.

( 5 )

PARA_NEO_BIFOLD_12/23/99