Coastal M-CBX9.6 2016 Kullanıcı El Kitabı - Sayfa 5

Tekne Coastal M-CBX9.6 2016 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Coastal M-CBX9.6 2016 16 sayfaları.

ASSEMBLY FOR BOATS WITH INFLATABLE DECK
Find flat surface where boat will be assembled.
Remove any sharp objects from the area where boat will be
assembled and inflated.
Unfold and spread boat out flat.
pavement or concrete!
Connect the pump to the valve by inserting the adapter attached
to the pump hose into the valve, turning it until it tightens. Do
not force it; simply turn it until it locks into place. When
inflating the boat with the hand pump, it is normal for the hand
pump to leak some air where the adapter connects to the valve.
Continue to pump until the tubes become hard.
Inflate the three tubes (Bow, Starboard & Port) to about 50%. If
the air rushes out when you detach the adapter from the valve,
you need to turn the pushpin in the center of the valve (see
above).
Unfold and stretch out the inflatable deck, edging it under the
half-inflated tubes and against the transom making sure the
deck is under the tubes as well as the boards attached to the
bottom of the transom.
If the keel valve does not line up with the opening located near
the bow, remove the floor, and inflate the keel to get any folds
that may have formed during shipping. Deflate the keel; it
should regain its proper shape. Re-inflate the three tubes to
about 50% making sure the keel valve now aligns with open in
the deck.
Inflate the air deck to about 70%
Install the aluminum seats into the seat straps.
Inflate the three tubes to 100%.
Inflate the air deck to 100%.
Inflate the keel to 100%.
Install the oars.
GO BOATING!!!
What is 100% full? Inflate the tubes & floor until the hand pump
becomes somewhat difficult to push down.
Never drag boat on
5