Coastal Amusements Hi-Striker X-treme Montaj ve Kurulum

Oyun Coastal Amusements Hi-Striker X-treme için çevrimiçi göz atın veya pdf Montaj ve Kurulum indirin. Coastal Amusements Hi-Striker X-treme 4 sayfaları.

Sayfayı Yazdır
Instructions for Hi-Striker X-treme
Assembly and Installation
1)
Start by placing the sawhorses that will support the tower while assembling (you
will need 4 to give you a level surface). **Note - During the assembly process,
place the Top Sign where the base will be mounted when the game is assembled
& erect.
2)
Place the upper tower section onto the sawhorses (LED side facing upward).
3)
Place the lower tower section onto the sawhorses with the LEDs facing upward
also.
4)
Slowly slide the upper tower section into the bottom section. When the two-tower
section are close enough, start connecting the mating white Molex
connectors. When sliding the upper section into the lower section be careful not
to allow the wires to be pinched between the tower sections. These connectors
should be able to be connected without removing the back panels. However, if
needed you can remove and re-install the panels.
5)
Remove the lower LED board from the upper tower section. Start by gently
pulling back the black gasket on either side of the LED board to expose the
screws. Once the tower sections are close enough, plug the upper LED board of
the lower section into the LED board on the upper section (short cable w/red
connector).
6)
Reinstall LED board screws and secure LED gasket back into place.
7)
Bolt the tower sections together using the (4) 3/8 x 1" hardware included in the
hardware kit.
8)
Once the tower sections are securely bolted together, use the weatherproof tape
provided on the Lexan seam. Be sure that the tape goes under both of the Lexan
gaskets and is securely adhered to the Lexan. This is a crucial part of
weatherproofing the game.
9)
Rotate the full tower body so that the LEDs are now facing downwards.
10) Slide the base onto the pole of the lower tower section. Be sure to leave enough
room to run the wires from the tower section into the base. **Note - The
transformer faces to the back of the tower.
11) Slowly bolt the base to the tower section. Be sure no wires get pinched between
the base and tower section.
12) Install the PCB enclosure. Be careful not to damage the black connectors on the
back of the box or tower. Gently angle and lower the control box into place while