10Bar GF1 Kullanıcı Kılavuzu - Sayfa 7

Kamera Aksesuarları 10Bar GF1 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. 10Bar GF1 9 sayfaları. Underwater housing for the panasonic gf1 camera

Sayfayı Yazdır

Replace the lid and make sure the lever is perpendicular to the side wall of the housing. Lock the

lid by press down the lever and turn until the lever is parallel to the side wall of the housing.

After replacing and locking the lid, make a final visual inspection of the main O-ring for

contamination.

Note: If the O-ring is in good contact, a thin black line, about 0.5 to 1mm in width should be

visible, where the O-ring is in contact with the lid. Follow this line all the way round the

edge of the seal, as a final check that the seal is good.

The housing is now ready for the dive.

5. Use & Care of Housing

5.1 Pre Dive Function Check.

Just before entering the water, make a habit of reviewing that you have carried out the proper

steps to close the housing and the bulkhead is connected. Make a visual check of the O-ring seal.

It is also useful to switch on the camera, and check that controls e.g. on/off, zoom, shutter

functions operate normally.

Check housing is closed

Check O-ring is in the groove between housing and Acrylic

Check battery and memory card status on the LCD display

Check control knob and zoom function.

Always avoid submerging the housing in hot water for a prolonged time or a cleansing

tank where the water may be heated up by the sun.

5.2 General Operation.