AcraDyne AES35075AV Kullanım Kılavuzu - Sayfa 3

Elektrikli Alet AcraDyne AES35075AV için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. AcraDyne AES35075AV 8 sayfaları. Inline 5000 series

Sayfayı Yazdır

Square/

Hex Drive

1. Connect tool cable to the iEC controller and the tool:

The tool cable has curved alignment tabs and slots

built into the connectors at each end to ensure proper

alignment and connection with the tool and controller.

Make sure that power is not turned on at the controller

before making any connections. Align the female connec-

tor on the cable with the male connector on the tool and insert

the cable onto the tool, then slide the connector nut onto the

threads on the cable and turn clockwise until hand-tight.

Align the male connector tab on the other end of the tool

cable with the female slot on the controller and insert the

cable into the connector, then slide the metal outer cover

onto the connection threads on the controller and turn clock-

wise until hand-tight.

2. Multifunction Button Operation:

The tool will flash all LED lights three times when power is

first turned on at the controller. After the controller finishes

initializing and displays a target toque value, the multifunction

button (MFB) is used to toggle the tool from clockwise mode

(FWD) to counter-clockwise operation mode (REV). The MFB

is the small button opposite the trigger.

The tool will initially start in clockwise mode and will have no

LED lights turned on. If the trigger is pressed, the tool will

turn on the blue LED meaning the tightening operation is

A complete tool system consists of the following items:

Controller

OPERATION

Angle Head

Tool Body

Power cord

Multi Function

Button

Start Lever

underway. Pressing the MFB will cause the tool to flash yel-

low and red LED lights. Pressing the MFB again will switch

the tool back FWD mode and will indicate this with no LED

lights turned on.

3. Start Lever Operation:

To start the tool, depress the start lever. Blue LED lights will

be displayed while tightening a bolt. The tool will stop auto-

matically when it senses its target torque value or if no torque

is sensed in a specified time period. After a cycle is complete,

the tool will display green LED lights for a success, or red

LED lights for failure to reach torque/angle.

Light Ring Light Assignment

The Buzzer and Multi-Function Button are programmable in the

DSP Menu of ToolWare.

Light Color

Meaning

Green Solid

Red Flashing

Torque Low

Red Solid

Torque High

Yellow Flashing

Angle Low

Yellow Solid

Angle High

Blue Solid

Tool In-Cycle/Tool Armed

Blue Flashing

P-Set Change thru MFB

All On Flashing

Tool in Disassembly

Buzzer

Bad Assembly/Tool in Disassembly/Power Up

Tool

Cable

Connection

Tool Cable