Acratech GPSS Kullanıcı Kılavuzu

Kamera Aksesuarları Acratech GPSS için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Acratech GPSS 2 sayfaları. Ball-heads

Sayfayı Yazdır

USING YOUR NEW BALLHEAD

1) Insert your camera, with a quick release plate

attached, into the clamp and securely tighten

the quick release knob. Carefully check that

there is no interference or binding on any part

of the tripod, ballhead or any camera accessory

being used. Make sure you can operate all

camera, tripod and ballhead controls without

interference and without pinching your hands

or fingers. If any interference or binding

occurs, contact us before continuing.

2) When using any tripod, ballhead or quick

release system always "test your setup" by

grasping the camera and trying to move it left,

right, up, down, etc. to make sure everything is

tight and secure before removing your hands

from the camera. This should be done every

time you put any camera on any tripod.

3) Never carry your camera while attached

to the ballhead.

4) The GV2 and GP ballheads can be used as

a gimbal head with lenses up to a 400 F4.0

and as ballhead with lenses up to a 600 F4.0.

USING YOUR NEW BALLHEAD

Caution should be used when using the

Gimbal position to avoid collisions between

the camera / lens and your tripod. Be sure to

verify that the tripod set-up is balanced and

will not fall over due to the weight distribution.

Keep your new ballhead clean and free from

debris. Clean by using a damp cloth. When

storing your ballhead for long periods of time,

the knobs should not be firmly tightened.

Do not oil or use WD40 on the ball.

Your new ballhead is equipped with special

knobs that cannot vibrate loose or fall off.

Do not try to remove the knobs or loosen

past the point where resistance is felt.

The GP ballhead can be used as a leveling

head for stitched panoramic images. To do

this, remove the quick release clamp from

the top of the ball using the provided Allen

wrench, now reinstall the quick release

clamp on the bottom of the ballhead, firmly

hand tight and install the GP ballhead upside

down onto your tripod.

Cont. page 6

ACRATECH INC

QUALITY PRECISION PRODUCTS

Cont. from pg. 5.

The level in the quick release clamp can

now be used to accurately level your

camera for stitched Panoramic images.

Thank you for choosing an Acratech product.

If your ballhead or any other Acratech product

needs service or repair, please send it directly

to Acratech. Do not return it to your dealer. If

you have any questions or comments please

call or e-mail us.

ACRATECH INC.

2502 Supply St. • Pomona, CA 91767

Office: (909) 392-7522 • Fax: (909) 392-8522

Web: www.acratech.net • E-mail: [email protected]

WARRANTY

All Acratech Products are fully guaranteed

for 10 years to the original purchaser. This

covers all manufacturing and material defects.