Aktakom ACM-2311 Kullanıcı Kılavuzu - Sayfa 6

Ölçüm Cihazları Aktakom ACM-2311 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Aktakom ACM-2311 7 sayfaları. 1000a ac clamp meter

Sayfayı Yazdır

Set the function switch to the

Use the multifunction MODE button to select resistance.

Touch the test probe tips across the circuit or component under test. It is best to

disconnect one side of the device under test so the rest of the circuit will not interfere

with the resistance reading.

For Resistance tests, read the resistance on the LCD display.

For Continuity tests, if the resistance is < 100, a tone will sound.

Diode Measurements

1. Insert the black test lead banana plug into the negative COM jack and the red test lead banana plug into

the positive diode jack.

2. Turn the rotary switch to the

3. Press the MODE button until "

4. Touch the test probes to the diode under test. Forward voltage will indicate 0.4V to 0.7V. Reverse voltage

will indicate "OL". Shorted devices will indicate near 0mV and an open device will indicate "OL" in both

polarities.

Red

Probe

Capacitance Measurements

WARNING: To avoid electric shock, disconnect power to the unit under test and discharge all capacitors

before taking any capacitance measurements. Remove the batteries and unplug the line

cords.

Set the rotary function switch to the cap position.

Insert the black test lead banana plug into the negative (COM) jack.

Insert the red test lead banana plug into the positive (V) jack.

Touch the test leads to the capacitor to be tested.

Read the capacitance value in the display

Frequency or % duty cycle measurements

1. Set the rotary function switch to the "Hz/%" position.

2. Insert the black lead banana plug into the negative COM jack and the red test lead

banana plug into the positive V jack.

3. Select Hz or % duty with the Hz/% button.

4. Touch the test probe tips to the circuit under test.

5. Read the frequency on the display.

Data Hold and Backlight

To freeze the LCD meter reading, press the data hold button. The data hold button is located on the left side

of the meter (top button). While data hold is active, the HOLD display icon appears on the LCD. Press the

data hold button again to return to normal operation.

Note: The HOLD feature will activate when the Backlight is turned on. Press the HOLD key again to exit

Hold.

•)))  position.

•))) position.

" appears in the display.

Black

Probe

Forward test

www.tmatlantic.com

Black

Probe

Reverse test

Red