Aktakom ATE-6008 Kullanıcı Kılavuzu - Sayfa 3

Ölçüm Cihazları Aktakom ATE-6008 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Aktakom ATE-6008 7 sayfaları. Contact/non-contact tachometer

Sayfayı Yazdır

* Flip open the battery compartment cover and install a

9V Battery.

* Non-Contact: Stick the self-adhesive reflective tape on

the object whose rotational speed is to be measured. The

reflective tape should be stocked as close to the outer

edge of the object to be measured as possible.

* Contact: Attach the contact adapter to the tachometer.

Select the adapter included and slides it onto the shaft of

the contact adapter. Align the adapter with the alignment

pin on the shaft of the contact adapter.

* Press the "MEAS" button .Point the laser spot at the

object or bring the contact probe to the object .Then read

the measurement on the LCD display.

4 Function Description

In scan mode, the current measurement is displayed

on the main display. The main display will hold the last

values until the tachometer automatically turns off.

* Data Storage: Press the "MEAS" button until the

reading displayed on the LCD display. Observe the

reading and press the "MEM" bottonto record. The

maximum,minimum,average and data during one shot

measurement will be stored into a memory set. Then the

Data numer will increase by one.

Recall Data: Use the "MEM" botton to scroll and

view the stored data point. Press the "MEM" button once

to next storage,you will view the MAX measurements,

MIN measurements, AVG measurements and DATA

measurements. Press the "MEM" button and don't to