aero-naut Princess Talimatlar Kılavuzu - Sayfa 12
Oyuncak aero-naut Princess için çevrimiçi göz atın veya pdf Talimatlar Kılavuzu indirin. aero-naut Princess 17 sayfaları. 3081/00
Sayfayı Yazdır
53
38
51
Epoxy the rudder shaft
51 in the rudder blade
52. Sand the rudder
blade 52 to the correct
52
profile.
The rudder is assembled
from parts 51 and 52.
53
49
13
39
Slip the rudder through the bush 49 from
the underside of the hull, fit the tiller 53
on the top end and tighten the retaining
screw.
54
55
40
Measure the distance between the holes in the servo output arm and the tiller, and
set the 1.5 mm Ø rudder pushrod to the correct length by bending both ends at
right-angles; the angled ends should be 8 mm long. Fit the pushrod through the
output arm and the tiller, push the retaining clip 54 onto the tiller 53, swivel it
round and clip it onto the pushrod 55. Fit the second retaining clip at the servo
output arm in the same way.
37
50
Adjust the opening in the servo plate 50 to
suit your rudder servo, and glue it in the
notches in the fore-and-aft bearers 13.
Glue the rudder bush 49 and the rudder
support plate 50 in the hull using two-pack
adhesive; the bush should project from the
underside of the hull by 6 mm.
54