Aktakom ASE-1203 Kullanım ve Bakım Kılavuzu - Sayfa 11

Lehimleme Tabancası Aktakom ASE-1203 için çevrimiçi göz atın veya pdf Kullanım ve Bakım Kılavuzu indirin. Aktakom ASE-1203 11 sayfaları. Intelligent lead free soldering station 2 in 1

Sayfayı Yazdır

4.2 Sleeping Setting

1. When the window displays

time, the window displays the current sleeping time, which means the

soldering iron has been into the sleeping time setting mode. Click to "▲"

or " ▼" button change the displaying value, the digit changing order is as the

followings:

2. After select the sleeping time, click the "ON/OFF" button to save the value

into the memory.

3. The sleeping settings of the two work soldering irons are separate and both

need to set. After finishing one setting, it needs to repeat the same steps to

setting the other.

5. Select a correct tip

1. Select a tip that maximizes contact area between the tip and solder joint.

Maximizing contact area gives the most efficient heat transfer, allowing

operators to produce high quality solder joints quickly.

2. Select a tip that allows good access to the solder joint. Shorter tip lengths

allow more precise control. Longer or angled may be needed for soldering

densely populated boards.

, press "▲" and "▼" buttons at the same

. . .

Page 9

6. Use and maintain

6.1 Care and Use of the Tip

Tip's temperature

High soldering temperatures can degrade the tip. Use the lowest possible

soldering temperature. The excellent thermal recovery characteristics ensure

efficient and effective soldering event at low temperatures. This also protects the

sensitive components from thermal damage.

Cleaning

Clean the tip regularly with a cleaning sponge, as oxides and carbides from the

solder and flux can form impurities on the tip. These impurities can result in

defective joints or reduce the tip's heat conductivity.

When using the soldering iron continuously, be sure to loosen the tip and remove

all oxides least once a week.

This helps prevent reduction of the tip temperature.

When not in use

Never leave the soldering iron sitting at high temperature for long periods of time,

as the tip's solder plating will be covered with oxide, which can greatly reduce the

tip's heat conductivity.

After use

Wipe the tip and coat it with fresh solder. This helps to prevent tip oxidation.

Page 10