Aktobis WDH-220B Manuel - Sayfa 7

Hava Temizleyici Aktobis WDH-220B için çevrimiçi göz atın veya pdf Manuel indirin. Aktobis WDH-220B 10 sayfaları.

of the air sensor compartment. Then open the air sensor compartment. Now clean all areas of the air sensor or the

air sensor board. Please use a soft (damp) cotton swab to clean the inlet, outlet and the sensor, and a dry cotton

swab to remove any water residue on the sensor. Finally, close the air sensor compartment again. (See the

diagrams below).

6.) Timer

With the timer function, you can conveniently determine or select the remaining running time of the air purifier. You

can select the following time periods by pressing the "TIMER" button:

 (1) = One hour

 (2) = Two hours

 (4) = Four hours

 (8) = Eight hours

(See chart opposite).

After the set time period has elapsed

the air purifier switches off automatically.

7.) Filter change / filter change indicator

The unit is equipped with a filter change indicator. Depending on the duration of use and the degree of soiling, this

may be signalled to you by a regular beep interval and by the LED lights in the display panel lighting up red !

This is the indication that the pre-filter should be cleaned and/or the fine filters replaced.

Notes: Disconnect the mains plug before cleaning/replacing the filters. For best filtration results, we strongly

recommend that you use only original filters from the manufacturer.

After cleaning the pre-filter and/or replacing the fine filters, it is necessary to press the reset button ! Then press the

reset button for approx. 3-5 seconds until you hear a short "beep". Please note that the air purifier must be

switched on for resetting! Finally, the air purifier should be switched off and briefly disconnected from the power

supply (pull out the mains plug). After that, your air purifier is fully operational again !

(See charts below:)

Aktobis AG, Borsigstr. 20, D-63110 Rodgau / Germany

www.AKTOBIS.de