Aerobics PaceMaster ProClub LT Kullanıcı El Kitabı - Sayfa 6

Koşu Bandı Aerobics PaceMaster ProClub LT için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Aerobics PaceMaster ProClub LT 18 sayfaları. Aerobics pacemaster proclub lt treadmill owner's manual

Sayfayı Yazdır

Grounding Instructions

DANGER:

This product must be properly grounded. If it should malfunction or become inoperable, grounding provides a path of least

resistance for electric current to reduce the risk of electric shock. This product is equipped with a cord having an equipment-grounding

conductor and a grounding plug. The plug must be plugged into an appropriate outlet that is properly installed and grounded in accordance

with all local codes and ordinances.

WARNING:

Improper connection of the equipment grounding-conductor can result in a risk of electrical shock. Check with a qualified

electrician or serviceman if you are in doubt as to whether the product is properly grounded. Do not modify the plug provided with the

product. If it will not fit the outlet, have a proper outlet installed by a qualified electrician. This product is rated for more than 15 amperes and

is for use on a circuit having a nominal rating of 120 volts. It is factory equipped with a specific electric cord and plug to permit connection to

a proper electric circuit. Make sure that the product is connected to an outlet having the same configuration as the plug. No adapter should

be used with this product. Attempting to bypass it with an adapter or in any way defeating its purpose can result in a serious shock hazard.

As a safety precaution you should unplug the treadmill during electrical storms or if the treadmill will not be in use for periods greater than

one week.

CAUTION:

If you need to use an extension cord it must be a 14 gauge, three wire cord, no longer than 12 feet.

Assembly

Figure 1:

Carefully place the bottom of the handlebar (1) on the frame (2) so the two

holes in the plate at the bottom of the handlebar line up with the holes in the

frame. Be extremely careful not to damage the speed sensor while

installing the handlebar.

Insert the 3.5" carriage bolts (3) through the handlebar and the frame.

Install a 1/4-20 kep nut (4) to each carriage bolt to keep the handlebar

in place. Follow the same procedure for the other handlebar. Do not

tighten any nuts until both sides are bolted in place.

Figure 1

Figure 2:

With the handlebar in place, plug the wire harness (5) into the socket (6)

on the power supply board (7).

Figure 2