American Sanders AVAC18 Operatör El Kitabı - Sayfa 6

Elektrikli Süpürge American Sanders AVAC18 için çevrimiçi göz atın veya pdf Operatör El Kitabı indirin. American Sanders AVAC18 20 sayfaları.

SAFETY WARNINGS FOR DRY VACUUM
Before using the appliance for the first time, read and comply with these safety warnings. Keep
these safety warnings for consultation in the future or to hand them over to successive owners.
Before commissioning, read the appliance's user manual. The warning plates on the appliance
provide important instructions for its safe use. Always comply with both the directions on the
instructions, as well as current safety standards. Keep the packing film out of the reach of children.
DANGER:
• To reduce the risk of fire, electric shocks or injury, please read and follow the safety instructions and
warning indications before using. This vacuum cleaner has been designed to be safe when it is used
for cleaning in the specified manner. If damage to electrical or mechanical components is found, the
vacuum cleaner and/or the accessory must be repaired at the relative authorized service center or
else at the manufacturer before use, in order to prevent further damage to the appliance or physical
injury to the user.
• Before connecting the appliance to the electricity socket, make sure the electrical information on
the plate corresponds to that of the electrical supply. The appliance must only be powered with
alternating current and voltage equal to that shown on the serial number plate.
• The power supply cable outlet must have an earth connection in compliance with the regulatory
standards.
• The cable for connecting to the electrical that is supplied with the appliance should be used for the
above-mentioned appliance and not for other appliances.
• Before using, check for any damage on the connection cable and on the power plug. If the cable is
damaged, immediately contact a technician for restoring normal functioning.
• Never touch the power plug with wet hands.
• Make sure that the cable to the electrical or the extension cable have not been damaged by having
been walked on, crushed, pulled or the like. Protect the cable from heat and from contact with oils or
sharp edges.
• Regularly check that the cable connecting to the electrical is not damaged, for example with signs of
ageing or cracks. If damage is found, the cable should be replaced before using the appliance again
• Protection against splashes of water and the mechanical strength need to be ensured also after any
replacement of the joints of the power cable or the extension cable.
• Do not clean the appliance with a hose or a jet of high pressure water (risk of short-circuit or other
electrical faults).
ATTENTION:
• The procedure causes short-term reduction in voltage.
• In unfavourable grid conditions the other appliances could be damaged.
• This damage could occur if the grid impedance is less than 0.15Ω.
SAVE THIS INSTRUCTION
Risk of asphyxiation!
CONNECTION TO THE ELECTRICITY GRID
6