Bobrick 1033 Kurulum Talimatları Kılavuzu - Sayfa 4

Tuvaletler Bobrick 1033 için çevrimiçi göz atın veya pdf Kurulum Talimatları Kılavuzu indirin. Bobrick 1033 10 sayfaları. Urinal screens, benches & shower seats

Sayfayı Yazdır

STEP 1

POST-TO-CEILING URINAL SCREENS

LAYOUT EXAMPLE.

Finish Face of Wall

5/8"

16mm

Top View

STEP 2

INSTALL ALL ANCHORS

FLOOR AND CEILING ANCHORS.

A. Drill 3/8" (9.5mm) diameter hole to depth shown. Remove all loose material from hole.

B. Insert anchor into drilled hole. Stud to be 2-1/2" (65mm) above floor.

C. Use 9/16" (14mm) wrench to tighten hex nut until anchor is expanded. Make sure shoe retainer is in proper position to

accept shoe. Angled ends to face front and rear of urinal screen.

D. Install second hex nut.

E. Place base plate over threaded rod.

NOTE: Wood-floor anchors are available upon request.

Fig. 2a: Detail of Floor Anchor.

2-1/2''

65mm

3-1/2''

90mm

For tile or concrete floors

using filler sleeve

Page 4

Form No. 1045-69 r5/21/14

Cut to

2-1/2''

4-3/4''

65mm

120mm

Overall

2''

50mm

Min.

For tile or concrete floors

without filler sleeve

A. Refer to Bobrick layout sheets for distance location on

screen depth.

B. From back wall, measure and mark the location of the

edge of the screen.

C. Centerline of floor anchor from edge of screen is 5/8"

(16mm).

D. Be sure, by plumb line, that floor and ceiling holes are

in line.

LEGEND:

Obtain Dimension from Bobrick Layout Sheet.

Mounting holes to be drilled.

Fig. 2b: Detail of Ceiling Anchor.

Spacer

Printed in U.S.A.

Drill 1/2'' (

) Hole in Ceiling.

12mm

Run Toggle Bolt through

Base Plate and Spacer, then

into Ceiling. Tighten securely.

Finish Face of Ceiling

Base Plate