Euro-Clear BlueSoft 1665EA-RX Tamirci El Kitabı - Sayfa 9
Su Sebili Euro-Clear BlueSoft 1665EA-RX için çevrimiçi göz atın veya pdf Tamirci El Kitabı indirin. Euro-Clear BlueSoft 1665EA-RX 15 sayfaları. Iron, manganese, ammonia and other natural organic matter removers, water softeners with ecomix media
Water purification and treatment equipment manufacturer and wholesale distributor
Tel: +36 96 544-240 • Fax: +36 96 544-248 • E-mail: [email protected] • Web: www. euro-clear.eu
In case the water pressure from the water system exceeds 6 bars, a device to
decrease pressure has to be fixed in front of the device.
Fluctuation of pressure higher than ±0,5 bar is not allowed! Mechanical protective
filter must be built in front of the device. It is important that the mechanical protective
filter filtrates contamination bigger than 100 microns.
The device does not have any extra protection against water or electricity shortage.
If needed, it must be provided while installing.
5.2. CONNECTING THE DEVICE (it is the customer's/owner's job)
It is the customer's task to have the device connected to the water, sewage and
electricity systems. The operator of the device and the specialist to complete the
installation should both check if the device has been installed as described in the
guide for use and handling and if the conditions to diminish risks of damage are
given. The setting up of the device can be completed by the partner of the Euro-
Clear Hungary Ltd's service that has a partnership contract. Setting up the device
only means the setting up of the automatical control valve fulfilling the local
conditions.
The pre-filtering device No. 1 and the montageblock No. 2 are already fitted in when
the customer gets them. The montageblock can be replaced by a by-pass branch
built from 3 valves. When building in this unit into the pipe, make sure that you
connect the raw water onto the filter „1" and the softened water that comes out has
to be connected onto the montageblock „2".
The device and the montageblock can be connected by the flexible tube pair No. 3.
When connecting, pay attention to the flow direction of the water which is marked by
the arrows at the montageblock No 2 and the control valve No 4.
BlueSoft Industrial Iron and Manganese Remover
Euro-Clear Kft.
When fitting, the valid local regulations,
general
regulations must be followed and the
technical parameters given above must
be respected.
1. Pre-filtering device
2. Montage block or a built by-pass
branch
3. Flexible tube pair
4.Control valve of the device
5. Sewage drainage
6. Electrical outlet
7. Gravitation drainage on the floor
instructions
and
hygiene
Page 9.