BOC Smoothcut Plasma 25 Torch Kullanım Kılavuzu - Sayfa 9
Plazma kesici BOC Smoothcut Plasma 25 Torch için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. BOC Smoothcut Plasma 25 Torch 12 sayfaları. Boc smoothcut plasma 25 torch plasma cutter
Sayfayı Yazdır
Diagram 2
45°
5.2 Piercing and Gouging
To pierce material the cutting torch should be held at an angle of 45°
to the pierce surface (Refer to Diagram 2). Once the arc is established
the torch is turned to 90° (Refer to Diagram 3) and cutting is carried out
in a normal manner. Piercing thickness is dependent on the output of
the machine and is generally 50% of the rated cutting thickness of the
power source.
It is important to direct the arc away from the operator when establishing
the arc as sparks and molten material will be ejected from the point
of contact. Care must also be taken to protect the surrounds from
these sparks.
When gouging with plasma it is advisable to use a plasma gouging tip
supplied by the torch manufacturer. The torch should be held at an angle
of 40–45° from the plate surface (Refer to diagram 4). An arc length of
up to 15 mm can be employed whilst the torch is moved in the direction
of the material to be removed. Several small passes should be made to
remove the unwanted material.
BOC Smoothcut Plasma 25 Torch Operating manual
Diagram 3
90°
Diagram 4
40–45°
Gouging Direction
9