Boca Systems LEMUR-X Kurulum - Sayfa 2

Yazıcı Boca Systems LEMUR-X için çevrimiçi göz atın veya pdf Kurulum indirin. Boca Systems LEMUR-X 4 sayfaları.

b. BOTTOM HOLE = 90°, 30°, - 30°, -90°

BOTTOM

Install the roll holder arm onto the mounting plate and secure it in place with the provided ¼" Hex head

#8 Taptite screw. Below photo shows the arm set to the 30° positions. Arm position will vary

depending on what degree position is used.

Slide the roll holder block onto the spindle with the sensor tab towards the roll.

This side towards

roll holder arm

Slide the block side the block all the way to the roll holder arm. See below photo.

Roll holder arm

Orientate the sensor tab so it is parallel to the floor or bottom of the printer.

Tighten the Philip screw on the block to hold it in place.

Outer holes line

up with Allen

screw

Philip head screw

Center hole lines

up with #8 tap

hole

Sensor tab

Spindle