Barnes MAK-18 Kullanım Talimatları Kılavuzu - Sayfa 5
Elektrikli Alet Barnes MAK-18 için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. Barnes MAK-18 12 sayfaları.
Sayfayı YazdırHand Extruder MEK-18 / MAK-18
• Extension cables must be certified for the specific
service conditions (e.g. outdoor service) and
identified accordingly.
Always handle the connecting cable with care.
-
Do not kink the connecting cable.
-
Do not place any objects on the cable.
-
Do not jam or squeeze the connecting cable,
nor pull it over sharp edges.
-
Protect the connecting cable from moisture.
•
Do not touch the mains connector or con-
necting cable with wet hands. Hold the cable al-
ways at the connector when plugging or unplug-
ging it.
• CAUTION Power generator sets used for power
supply must be designed for the following rated
output:
≥ 4 x rated output of hand extruder
•
Never allow the hand extruder to come into
contact with water: Hazard to persons and
equipment, short-circuit risk.
• CAUTION Never operate the hand extruder
without air supply; risk of hand extruder dam-
age.
When using an external air source, make sure
that the air supply line is adequately dimen-
sioned.
• CAUTION The supply air must be clean, dry and
free from oil and water.
Page 6/20
•
The hand extruder must not be used in
explosion hazard areas or flammable atmos-
pheres.
Make sure that the hand extruder is firmly posi-
tioned during the extrusion welding job.
The connecting cable, welding rod and hose for
external air supply, if applicable, must be freely
movable and must not obstruct the operator or
third parties in their work.
•
Hold and touch the hand extruder only on
the handles provided for this purpose.
- Do not touch bare metal parts (including hot
air hood) either with or without gloves. These
parts reach temperatures of up to 350 °C.
- Attachments may be damaged or impaired
in their function if subjected to the full weight
of the hand extruder.
- Bare metal parts must not come into contact
with other items during the work or work
breaks (e.g. cooling).
•
Contact of combustible components
with hot bare metal parts poses a risk of fire!
Do not use synthetic gloves!
Issue 08.2008/Rev. 00
D02-0001
MUNSCH Kunststoff-Schweißtechnik GmbH