Barnes MEK-18 Kullanım Talimatları Kılavuzu - Sayfa 8

Elektrikli Alet Barnes MEK-18 için çevrimiçi göz atın veya pdf Kullanım Talimatları Kılavuzu indirin. Barnes MEK-18 12 sayfaları.

Sayfayı Yazdır

Driven by a powerful electric motor (1), the welding

rod (2) is fed into the extruder (3) and granulated by

the extruder screw in the process. The screw forces

the granulate into the extruder nozzle, melting it into

a homogeneous, completely plastified mass. As the

molten material exits the extruder nozzle, it is

moulded by a welding shoe (4) to the geometry of

the weld seam to be deposited.

Preheating of the base material to be joined is ac-

complished by a preheating nozzle (5) which is sup-

plied from an integrated hot air unit (6). Air is sup-

plied either from an external compressor or an on-

board blower .

Melt and preheat temperatures are controlled sepa-

rately. The setpoint and momentary values are dis-

played concurrently.

The melt temperature must have reached the preset

start interlock temperature for the startup timer to

be activated. After the startup timer has timed out,

the start interlock will be released and the extruder

can be started.

The temperature-controlled start interlock prevents

the drive from starting if there is still unmolten mate-

rial in the extruder, thus precluding damage to the

unit.

The output rate is variable so that the preheat tem-

perature can be matched to the weld thickness.

5 Startup and Shutoff

5.1 General

In addition to the operating instructions and the na-

tional and local accident prevention regulations ap-

plicable at the place of use, the acknowledged tech-

nical rules for safe and proper working practices

must be observed.

Any working practices posing a safety risk are pro-

hibited.

MEK-18 / MAK-18

Before starting / shutting off the hand extruder, make

sure to carefully read the instructions under section

"Safety".

Only trained and qualified personnel may be as-

signed to the operation of the hand extruder.

5.2 Preparation

• Place hand extruder on a firm support and secure

them against toppling over as shown in the illus-

tration.

• Mount hot air hood

• Position handle

Loosen handle (55) and move it to the ideal work-

ing position by pushing it back and forth. The

handles of these extruder models can also be

swivelled upward and downward.

• Only for type MEK hand extruder with external

air supply:

Connect the hand extruder to the external air

source using the hose coupling LW 13 / NM 7.2

provided for this purpose (quick connect-

disconnect); set air rate to 300 l/min at 0.4 bar. A

suitable controller with flow metering function is

recommended for setting the air rate.

CAUTION The supply air must be clean, dry and

free from oil and water.

Never connect an external air source to a

MAK hand extruder.

Issue 08.2008/Rev. 00

Page 9/20