American Standard Antiquity 1.6 GPF One-Piece Toilet 2038.016 Kurulum Talimatları - Sayfa 4

İç Mekan Mobilyaları American Standard Antiquity 1.6 GPF One-Piece Toilet 2038.016 için çevrimiçi göz atın veya pdf Kurulum Talimatları indirin. American Standard Antiquity 1.6 GPF One-Piece Toilet 2038.016 4 sayfaları. American standard antiquity 1.6 gpf one-piece toilet installation instructions

Sayfayı Yazdır

American Standard Antiquity 1.6 GPF One-Piece Toilet 2038.016 Kurulum Talimatları

LIFT ARM

FIRST

IMPORTANT: Always

clear sand and rust from

system.

• Make sure water supply is

off. Remove valve TOP by

lifting arm and rotating top

and arm 1/8 turn

counterclockwise, pressing

down slightly on cap.

GUARANTEE: This Fluidmaster product is guaranteed to be free from defective materials and

workmanship for a period of one year. Units returned to Fluidmaster will be replaced without charge.

Always use quality Fluidmaster repair parts when maintaining your Fluidmaster products. Fluidmaster

shall not be responsible or liable for any damages caused by products used with Fluidmaster valves

that were not manufactured by Fluidmaster, Inc.

PROBLEM

POSSIBLE CAUSE

Does not flush

a. Water supply valve closed.

b. Supply line blocked.

c. Flush valve chain too loose or disconnected.

d. Sand or debris lodged in water control.

Poor or sluggish flush

a. Bowl water level too low.

b. Supply valve partly closed.

c. Partially clogged trapway and/or drain pipe and/or vent.

d. Supply pressure too low.

Toilet leaks

a. Poor supply line connection.

Toilet does not shut off

a. Flush valve chain too tight, holding flush valve open.

b. Flush valve seat and/or flapper worn or deformed.

If inspection of this American-Standard plumbing product, within one year after its initial purchase, confirms that it is defective in materials or workmanship, American-Standard

will repair or, at its option, exchange the product for a similar model.

This warranty does not apply to local building code compliance. Since local building codes vary considerably, the purchaser of this product should check with a local building

or plumbing contractor to insure local code compliance before installation.

This warranty shall be void if the product has been moved from its initial place of installation; if it has been subjected to faulty maintenance, abuse, misuse, accident or other

damage; if it was not installed in accordance with American-Standard's instructions; or if it has been modified in a manner inconsistent with the product as shipped by American-

Standard.

American-Standard's option to repair or exchange the product under this warranty does not cover any labor or other costs of removal or installation, nor shall American-

Standard be responsible for any other incidental or consequential damages attributable to a product defect or to the repair or exchange of a defective product, all of

which are expressly excluded from this warranty. (Some states or provinces do not allow the exclusion or limitation of implied warranties, so this exclusion may not apply to

you.)

This warranty gives you specific legal rights. You may have other statutory rights that vary from state to state or from province to province, in which case this warranty does not

affect such statutory rights.

For service under this warranty, it is suggested that a claim be made through the contractor or dealer from or through whom the product was purchased, or that a service request

(including a description of the product model and of the defect) be sent to the following address:

In the United States:

American Standard Inc.,

P.O. Box 6820

Piscataway, New Jersey 08855

Attention: Director of Consumer Affairs

For residents of the United States, warranty information may also be

obtained by calling the following toll free number: (800) 442-1902

• Replace TOP by engaging

• While holding a

container over the

lugs and rotating 1/8 turn

uncapped VALVE to

clockwise. MAKE CERTAIN

prevent splashing, turn

TIP IS TURNED TO THE

water supply on and off a

LOCKED POSITION.

few times. Leave water

VALVE MAY NOT TURN

supply off.

ON IF TOP IS NOT FULLY

TURNED TO THE LOCKED

POSITION.

Sand or debris lodged in water control.

AMERICAN-STANDARD ONE-YEAR LIMITED WARRANTY

LIFT ARM

FIRST

TROUBLESHOOTING GUIDE

CORRECTIVE ACTION

Open valve and allow water to fill tank.

Shut off water supply, disconnect supply line, and inspect

all gaskets and washers. Reassemble. Also, see Fluidmaster

maintenance (see step 12).

Readjust chain length as required.

Shut off water supply. Remove cap and clean per Step 12.

Check that refill tube is connected to water control and

inserted into tank overflow without being kinked or damaged.

Open supply valve fully. Be sure that proper supply tube size is used.

Remove obstruction. Consult a plumber if necessary.

Normal supply pressure must be at least 20 psi.

Review Step 8 of installation procedure.

Readjust chain length as needed. Review step 9.

Replace flapper/flush valve assembly, as needed.

Shut off water supply. Remove cap and clean per Step 12.

In Canada:

American-Standard,

2480 Stanfield Rd.,

Mississauga, Ontario

Canada L4Y 1S2

Toll Free: (800) 387-0369

- 4 -

TROUBLESHOOTING

IF FILL VALVE SHUTS OFF BUT CONTINUES TO LEAK

SLOWLY, repeat Step 12.

IF FILL VALVE TURNS OFF AND ON DURING PERIODS OF

NON-USE, it is a signal you are wasting water because:

• The end of the refill tube is inserted into overflow pipe, below

water level in tank. Attach refill tube to overflow pipe using "S"

clip provided.

• The flush valve is leaking because it's worn, dirty or misaligned

with tank ball or flapper (replace with a new flapper).

IF FILL VALVE WON'T TURN ON OR SHUT OFF or REFILL

OF TANK WATER IS SLOW after valve has been in use for

some time, Fluidmaster Model 242 Replacement Seal may be

needed.

Go to our website at www.fluidmaster.com for more

solutions to toilet problems.

For troubleshooting information please contact:

30800 Rancho Viejo Road

San Juan Capistrano, CA 92675

(949) 728-2000 (800) 631-2011

www.fluidmaster.com

In Mexico:

Customer Service Manager

Ideal Standard, S.A. de C.V.

Via Morelos #330

Col. Santa Clara

Ecatepec 55540 Edo. Mexico

® Registered trademark of Fluidmaster, Inc.

7 3 0 4 6 5 - 1 0 0 R e v. B