American Standard Colony 1730.018C Teknik Özellikler - Sayfa 2
Küvetler American Standard Colony 1730.018C için çevrimiçi göz atın veya pdf Teknik Özellikler indirin. American Standard Colony 1730.018C 2 sayfaları. Corner whirlpool and bathing pool high gloss
Sayfayı Yazdır
1064mm
(41-7/8)
ALT.
PUMP
1546mm
(60-7/8)
318mm
686mm
(12-1/2)
(27)
1168mm
(46
(6) JETS
C/L OF DRAIN
2134mm
(84
)
TOP OF
51mm
DECK
(2)
*
445mm
(17-1/2)
70mm
(2-3/4)
BATH SUPPORT
MATERIAL
GENERAL SPECIFICATIONS FOR 1730 WHIRLPOOL
INSTALLED SIZE
WEIGHT
WEIGHT w/WATER
GAL. TO OVERFLOW
WHIRLPOOL MIN. OPERATING VOL.
BATHING WELL AT SUMP
BATHING WELL AT RIM
WATER DEPTH TO OVERFLOW
FLOOR LOADING
(PROJECTED AREA)
PTS.
CUBE (FT
)
3
WHIRLPOOL ELECTRICAL SPECIFICATIONS
SYSTEM I PUMP
NOTES:
BATH CAN BE INSTALLED EITHER ABOVE OR BELOW FLOOR LINE AS PIER, ISLAND, OR PENINSULA TYPE INSTALLATION. SUMP OF
BATH IS SUPPORTED BY INTEGRAL FEET. NO ADDITIONAL SUPPORT REQUIRED. ENCLOSING MATERIAL BY OTHERS.
■
REFER TO INSTALLATION INSTRUCTIONS SUPPLIED WITH WHIRLPOOL FOR ADDITIONAL INFORMATION.
CONCEALED PIPING NOT INCLUDED.
FITTINGS NOT INCLUDED AND MUST BE ORDERED SEPARATELY.
●
IF INSTALLING A DECK-MOUNTED FITTING, BEFORE DRILLING ANY HOLES: CHECK FOR INTERFERENCE WITH CIRCULATING
SYSTEM PIPING, DRAIN OVERFLOW, AND APRON INSTALLATION. MOUNTING HOLES DRILLED BY INSTALLER.
PROVIDE SUITABLE REINFORCEMENT FOR ALL SUPPORTS.
IMPORTANT: Dimensions of fixtures are nominal and may vary within the range of tolerances established by ANSI Standard Z124.1. These
measurements are subject to change or cancellation. No responsibility is assumed for use of superseded or voided pages.
© 2008 AS America Inc.
1514mm
(59-5/8)
PUMP
PROVIDE ACCESS
FOR SERVICING
PUMP & CONTROLS
ON/OFF
)
SWITCH
2 AIR
OUTLET
VALVES
83mm
(3-1/4)
495mm
(19 -1/2)
ROUGH
38mm (1-1/2)
FLOOR
O.D. TAILPIECE
60 x 60 x 19-1/2 In.(1524 x 1524 x 495mm)
115 Lbs. (52 Kg.)
908 Lbs. (412 Kg.)
95 Gal. (360 L.)
65 Gal. (246 L.)
30 x 50 In. (762 x 1270mm)
45-1/2 x 63-1/2 In.(1156 x 1613mm)
13 In. (330 mm)
36 Lbs./Sq. Ft. (177 Kgs/Sq. m.)
1.25 HP, 9.9 AMPS, 120V.
WHIRLPOOL AND BATHING POOL
1064mm
(
41-29/32
)
1549mm
(61
)
483mm
(19)
686mm
(27
)
LEVELING
STRINGER
TOP OF
NOT FOR
SUPPORT
38mm
(1-1/2)
117mm
457mm
(4 -5/8)
(18
)
ROUGH
FLOOR
101x101mm
4 x 4" FEET
GENERAL SPECIFICATIONS FOR 1730 BATHING POOL
INSTALLED SIZE
WEIGHT
WEIGHT w/WATER
GAL. TO OVERFLOW
BATHING WELL AT SUMP
BATHING WELL AT RIM
WATER DEPTH TO OVERFLOW
FLOOR LOADING
27.8
(PROJECTED AREA)
54
PTS.
CUBE (FT 3 )
H72
COLONY CORNER™
876mm
876mm
(34-1/2)
(34-1/2)
1168mm
(46
)
C/L OF DRAIN
OUTLET
79mm (
3-1/8
)
DECK
38mm (1-1/2) O.D. TAILPIECE
BATH SUPPORT
MATERIAL
60 x 60 x 19-1/2 In.
(1524 x 1524 x 495mm)
30 x 50 In. (762 x 1270mm)
45-1/2 X 31-1/2 In. (1156 x 1613mm)
36 Lbs./Sq.Ft. (174 Kgs./Sq.m)
HIGH GLOSS
1511mm
(59-1/2)
6.3mm (1/4) INTEGRAL
TILE FLANGE (2 SIDES)
19mm (
3/4
)
686mm
(27
)
LEVELING STRINGER
NOT FOR SUPPORT
495mm
(19 -1/2)
56mm
(2-7/32
)
95 Lbs. (43 Kg.)
888 Lbs. (403 Kg.)
95 Gal. (360 L)
13 In. (330mm)
27.8
54
Revised 2/08