D2G gravitee GK-2009 Manuel - Sayfa 3
Monitör D2G gravitee GK-2009 için çevrimiçi göz atın veya pdf Manuel indirin. D2G gravitee GK-2009 9 sayfaları. 10' x 20' display
Sayfayı Yazdır
© 2023
Order #XXXXX
General Setup Instructions
- Read entire setup instruction manual prior to
unpacking parts and pieces.
- The setup instructions are created specifically
for this configuration.
- Setup instructions are laid out sequentially in
steps, including exploded views with detailed
explanation for assembly.
Cleaning & Packing
- For Cleaning Metal, Plex, & Laminate Parts:
Use a MILD NON-ABRASIVE cleanser and
soft cloth/paper towel to clean all surfaces.
- Keep exhibit components away from heat
and prolonged sun exposure.
Heat and UV exposure will warp and
fade components.
- Retain all provided Packing Materials.
All provided packing materials are for
ease of repacking & component protection.
Disassembly
- For loss prevention, tighten all set screws
and locks during disassembly.
General Information
Assembly
Side-by-Side Assembly
1) Frames: Place frames side-by-side with one higher than the
other, then slide panel down to lock panels securely together.
2) Corner Connectors: Repeat Step 1 for installing corner
connectors to frames.
Corner A
Corner B
Corner D
Corner C
Step 1
It is important to first insert graphic
Insert corner A.
into each alternate corner, then to
Turn edge of graphic so silicon welt
the sides of the frame.
is perpendicular to face of graphic.
If this is not done, graphic will not fit
Insert narrow side of welt with fabric
into the frame correctly.
to outside into the channel.
Repeat for other side of this corner.
Assembly Cont'd
Push pin lock into hole of connecting frame.
Note: Block on pin lock will secure in groove.
Side-by-Side
1) Pull pin lock outwards to disengage.
2) Pull frames upward and apart at the same time to detatch.
SEG Graphic Installation
Step 2
Step 3
Repeat Step 1 for opposite corner
Once all corners are inserted, press
C, then insert corner B, followed by
one silicon edge into channel from
corner D, to complete the
corners and work toward the center.
installation of the corners.
Make sure welt is fully inserted into
channel. Continue until all sides are
done. Smooth out edges of graphic.
Pin Lock
Disassembly
Graphic Removal
To remove the graphic from
the frame, locate the fabric
pull tab.
Gently pull up on the tab to
remove the fabric.